Sealey HT105LED User manual

INSTRUCTION MANUAL FOR:
CORDLESS HEAD TORCH CREE LED 3W
RECHARGEABLE
MODEL NO : HT105LED.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give
you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
Original Language Version
© Jack Sealey Limited
1. SAFETY INSTRUCTIONS
1.1. GENERAL
 WARNING! Disconnect lamp from mains power before performing
any maintenance.
 DO NOT shine lamp directly into your, other person’s or animal’s
eyes.
 DO NOT allow children to use the lamp unsupervised.
Maintain the lamp in good condition.
 DO NOT use the lamp if the lamp if damaged.
1.2. ELECTRICAL SAFETY FOR USE OF
TRANSFORMER. USE ONLY THE SUPPLIED
TRANSFORMER PLUG FOR CONNECTING LAMP TO THE POWER
SUPPLY.
 WARNING! It is the user’s responsibility to read, understand and
comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the
installation of appropriate safety devices. An RCCB (Residual
Current Circuit Breaker) should be incorporated in the main
distribution board. We also recommend that an RCD (Residual
Current Device) is used with all electrical products, particularly
portable equipment which is plugged into an electrical supply not
protected by an RCCB.
You must also read and understand the following instructions
concerning electrical safety.
1.2.1. The Electricity At Work Act 1989 requires all portable
electrical appliances, if used on business premises, to be tested by a
qualified electrician, using a Portable Appliance Tester (PAT), at least
once a year.
1.2.2. The Health & Safety at Work Act 1974 makes owners of
electrical appliances responsible for the safe condition of the appliance
and the safety of the appliance operator. If in any doubt about
electrical safety, contact a qualified electrician.
1.2.3. You must ensure that you:
Inspect the transformer plug, cable and connector for wear and
damage to ensure items are safe before
connecting to the mains power supply. If worn or damaged DO NOT
use.
Important: Check that the voltage marked on the transformer plug is
the same as the power supply to be used.
Uncoil the cable between transformer plug and lamp.
 DO NOT pull the transformer plug from the mains socket by the
lead.
 DO NOT use any other type of transformer with this product.
 DO NOT try to take the transformer plug apart.
 DO NOT use the transformer plug to power any other electrical item.
 DO NOT get the transformer plug wet, or use in wet, damp
conditions (for indoor use only).
 WARNING! NEVER substitute a standard 13amp 3 pin plug, or any
other type of plug, for the transformer plug.
This transformer plug reduces and rectifies the mains voltage
(230 volts AC) to 3.7V DC.
HT105LED.V2 Issue: 1 - 29/03/16
WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which must be applied by the operator.

Battery Removal
Remove the two screws on the back of the battery unit, remove the lid and cut the two wires to remove the battery.
Dispose of it according to local government guidelines.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to
inform potential purchasers of products containing batteries (as defined within these regulations), that they are
registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number
(BPRN) is BPRN00705.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
4.1 Before the unit is disposed of at the end of its life, it is a requirement that the battery is removed. Refer to the battery removal section below.
4. MAINTENANCE
3. OPERATION INSTRUCTIONS
3.1. CHARGING
3.1.2. To charge remove the lead from the head torch and plug in the charger lead. Remember to plug the lamp lead back in after charging.
3.2 OPERATION
3.2.1. Adjust the three straps to fit your head size.
3.2.2. To turn on press the orange button on the back of the torch unit, once for brightest, again for low light and again for flashing and once
more to turn off.
NOTE: The torch will not operate whilst being charged.
Hands free CREE LED spotlight with adjustable inclination to direct light as required. Features three settings: full light, low light or flashing.
Adjustable headband and foam brow for added comfort. Powered by rechargeable 3.7V 2.0Ah Li-ion battery. Supplied with mains charger.
Model No: ............................................................................. HT105LED.V2
Cell Type:..........................................................................3.7V 2.0Ah Li-ion
Lumen Output:................................................................................... 120lm
LED: ............................................................................................. 3W CREE
Operating Time:....................................................................................3hrs
Charging Time: .....................................................................................4hrs
2. INTRODUCTION
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
WEEE Regulations.
Dispose of this product at the end of its working life in compliance
with the EU Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. Contact your local solid waste
authority for recycling information.
Parts support is available for this product. to obtain a parts listing and/or diagram, please log on to www.sealey.co.uk,
email: [e-mail] or telephone: [phone].
Original Language Version
© Jack Sealey Limited HT105LED.V2 Issue: 1 - 29/03/16
01284 757500
01284 703534
[e-mail]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk