Sealey TP696 User manual

INSTRUCTIONS FOR
VACUUM OIL/FLUID EXTRACTOR 5.5 LTR
MODEL NO: TP696
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9Keep the extractor clean and maintain it in good condition (use an authorised service agent).
9Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous
9and will invalidate the warranty.
9Keep all non-essential persons away from the work area.
9Check extractor connections and fittings before use.
9Ensure that the tank capacity exceeds the amount of fluid to be collected.
8DO NOT use the extractor for any purpose other than that for which it is designed.
8DO NOT operate the extractor if any parts are damaged or missing as this may cause failure
and/or personal injury.
8DO NOT leave the extractor operating unattended.
WARNING! Engine oil will be hot when extracting.
IMPORTANT! Ensure that you wear protective clothing, gloves, goggles, face mask as appropriate
for the fluid being extracted.
WARNING! DO NOT allow uncontrolled discharge of fluids thus polluting the environment.
8DO NOT use the unit to extract dangerous chemicals, poisons, acids, alkalines or solvents.
8The container is not designed for long term storage.
8DO NOT store the unit under extreme conditions.
8DO NOT turn the container upside-down when it is holding fluids.
8DO NOT adapt the unit for any other purpose.
1.1. Dispose of waste fluids in accordance with local authority regulations.
WARNING! DO NOT use with gasoline or other flammable liquids.
1.2. When not in use, disconnect from the air supply and store in a safe, dry, childproof area.
2. i INTRODUCTION
5.5ltr Capacity device constructed from composite materials and suitable for the extraction of engine oils from cars, motorcycles,
 marineengines,stationaryenginesandindustrialmachinery.Suitablealsoforlowviscosityuidssuchaswater.Supplied 
with 2100mm suction probe, easy-pour spout and cover cap. Use suction probe to remove engine oil through the dipstick tube.
3. i SPECIFICATION
Capacity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.5 litre
Overall length of suction probe . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2100mm
4. ASSEMBLY
NOTE: The black section of the probe is permanently joined to the clear section and cannot be separated.
4.1. Screw handle (F) onto pump shaft (B).
4.2.  Replaceredcaponcontainer(G)withtubecap(D)andxrmly.
4.3. Before attaching pump (B), make sure the black rubber collar (E) on container(A)isrmlyseated.
fig.1
TP696 Issue 2 (H, F) 11/01/18
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear Protective
Gloves
Wear Eye
Protection Wear Protective
Clothing

5. OPERATION
5.1. Pre-run engine for 10 minutes, to warm the oil and to allow any sludge or contaminants within the oil to mix and to suspend.
5.2.  Switchengineo󰀨andremovedipstickfromvehicle.
5.3. Insert black part of suction probe into vehicle dipstick pipe until it reaches the bottom of the oil pan.
5.4.  Withtwohandspumphandle(F)10to20times.Oilwillowoutautomatically.
8DO NOT PUMP CONTINUOUSLY- DO NOT FORCE THE PUMP HANDLE.
5.5. After extracting, remove tube cap (D) from container with a twisting action.
5.6.  Removepump(B)fromcontainer(A),attachpourspout(C)andemptyoil(uid)intoasuitablereceptacleforsafedisposal.DO NOT
hold the container upside-down.
6. MAINTENANCE
6.1.  Keeptheunitclean,wipeo󰀨anyuidspillage.Keepthesuctiontubescleanandclearofblockages.Checkthatalltubes,hosesand
connections are in good condition.
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
TP696 Issue 2 (H, F) 11/01/18