SEARIAL CLEANERS PIXIE DRONE Setup guide
QUICK START USER GUIDE
PIXIE DRONE
2Quick Start
Pixie Drone
BEFORE FIRST USE
Unloading and Charging
1. Release the O button
2. Press the On button for 10 seconds. The On
button must remain blue. Standby mode is
activated
3. Start the remote : press the On button, the
remote will connect to the drone
4. A loading bar appears: the drone and remote
are connecting
5. The loading bar disappears. The drone and
remote are connected.
6. Press the C button. This button allows you to go
from Standby mode to On mode
7. The Drone beeps
8. The beeping stops, the drone is ready to be set
into action.
Starting the drone
Button layout on the remote
Standby mode : allows to charge the drone
On mode : is when the thrusters and cameras are
on. Do not transport or charge the Pixie Drone in
this mode.
Beware : Do not transport, charge, perform any
maintenance or touch thrusters when the on
mode is activated
• Unload the Drone
• Place it on a soft surface to avoid scraping the hull.
Charge the drone overnight, batteries must be charged 100% before rst use.
At least two people are necessary to carry the drone.
Please read this user guide carefully to learn key best practices. Beware that this guide is not a substitute of the
technical notice.
3
Quick Start
Pixie Drone
Cleaning
Rinse the drone with clear water after each use. We recommend using a soft sponge with soap.
In the event of a prolonged stop - over 1 month :
- clean the drone
- charge the batteries prior
- charge the batteries every month
Storing
Strictly store in a dry environment.
We recommend storing the drone on a soft surface
Temperature strictly must remain between 0 and 40°C. // 32 and 104°F
BEWARE: Below 0°C / 32°F, batteries won’t be able to charge.
Charging the drone
Charge the drone after every use
To fully charge : allow a 5 hour charge. Charging must be strictly performed in a dry environment.
Warning : Never charge the drone on the water.
1. Activate Standby mode - refer to starting the drone
2. Plug the charger, the socket is located upfront, on the right hand side of the drone. Refer to the drawing.
3. Plug the charger on the power supply.
Maintenance recommandations
www.searial-cleaners.com
AFTER SALES CONTACT
Adress :
ROTAX MARINE
ZI LE MARAIS - Rue de l’Insdustrie
01460 PORT
Table of contents
