
3-way switch on panel underneath chart table. Hold to “manual” for continuous or “auto”
for intermittent with a float switch. Always leave the switch on “auto” before leaving the
boat.
Socket located aft portside in the cockpit. Handle is stowed in the chart table.
To operate:
1. Insert handle into socket
2. Move handle up and down to allow the pump to prime. When the pump is
primed, moving the handle will be harder, but keep pumping as water is moving
through and out the bilge exit thru hull. Pumping will become easier as water
exits the boat.
3. Remove handle and place back in the chart table.
An additional hand pump is located inside the port cockpit locker.
Has an icebox; no electrical system. Icebox drain is under the galley sink.
Fueled by propane.
Basic Operation (detailed operation located in boat manual):
1. Open gate valve on propane tank
2. Turn on the solenoid switch located on the DC panel labeled “gas valve”.
3. Light the propane lighter holding next to the desired burner.
4. Push the knob in and turn the gas control knob on the stove to light. Once lit, keep
pushing the knob in for 15 seconds to activate the safety sensor.
Shut Down:
1. Turn off the solenoid switch “gas valve” on the panel
2. Once flame is extinguished, turn off knob(s) on stove
3. Turn off the valve on the propane tank. Especially make sure this is closed at the
end of the day.
Y-valve to both water tanks is located under the cabin sole.
Seacock located in a cabinet under the sink.
See manual for operating water pressure.
Seacock located under sink
AC and engine heat exchange operated. 12 gallon capacity. Make sure tank(s) have water
before operating.
2 Anchors: primary in the bow anchor locker, secondary starboard side anchor well.
Primary Anchor: 25 lb. CQR w/ 130’ chain and 140’ line.
Secondary Anchor: Secondary Danforth w/chain in STB deck locker.140’ extra line in
anchor locker for either system.
Windlass: See boat manual for detailed information and step-by-step guide on usage.