Secret Lab TITAN Evo 2022 User manual

SECRETLAB CHAIR SKIN USER MANUAL
Slide the backrest sleeve over your chair and
pull it down the seat's backrest.
02
Unzip the side and bottom zippers.
01 Ensure holes on the backrest sleeve align
with the lumbar knobs on the chair wings.
03
Once the backrest sleeve is securely on, zip
down the zippers on either side of the
backrest sleeve and adjust for a snug fit.
04 Locate two straps at the base of the backrest
sleeve. Route them through the gap between
the seat’s backrest and seat base, then tug
gently to reinforce fit.
06
Pull both straps upward and
tuck them in.
07 Connect the top and bottom zipper of the
upper and lower backrest sleeve and zip
close. If straps slip out, simply tuck them
back upwards and continue zipping.
08
Incline the backrest all the
way forward.
05
Adjust backrest sleeve for the best fit.
Starting from the chair’s side wings, lightly
tug the sleeve inwards or outwards to align
the seams and accents of the sleeve with the
edges of your chair.
09
Before you get started, a few pointers:
Please ensure that your chair is free from visible dust or dirt before installation.
Adjust your armrests horizontally to their most outward positions.
Optional: Use a cloth iron on low heat to smooth out any minor creases in either sleeves before assembling.
●
●
●
BACKREST SLEEVE ASSEMBLY
PAGE 1 OF 2

Pull the seat base sleeve over the seat base
and ensure general alignment.
01
Incline the backrest all the way forward.
03 Slide seat base sleeve through the gap between the backrest and base. Gently tug the quick-release
buckles to ensure a better fit.
04
Clip and secure quick-release buckles below the seat base and ensure that the
straps are placed above the tilt levers.
05 Adjust seat base sleeve for the best fit.
Lightly tug the sleeve inwards or outwards
to align the seams and accents of the
sleeve with the edges of your chair.
06
Align the side of the sleeve insert with the side
of the recline cover, then slide it in.
a.
b. Tuck the top of the sleeve insert into the gap
between the seat base and recline cover.
SEAT BASE SLEEVE ASSEMBLY
Once the seat base sleeve is on, slide in the
sleeve inserts on the left and right sides of
the seat base sleeve. Ensure they are
securely slotted in.
02
Note: When installing the right sleeve insert, do
not apply any pressure on or pull the recline lever
to prevent accidentally adjusting the backrest.
PAGE 2 OF 2