Securiturk WT-M-1708-00IC User manual
WT-M-1708-00IC! ! /1 3
Short introduction
!
""!
Installation
SECURITURK
Document No: S20202K00021
www.securiturk.com!
www.elektronik-guvenlik.com
Technical information
Card Reader
13,56MHZ Mifare Card Reader
Standby Current
30µA
Administrator Card
1
Operating Current
130mA
User Card
21
Operating Temperature
-20 ~ +55℃
Compatible Battery
3 x AAA Battery
Op. Humidity Range
10% ~85%
Battery Life
10.000 Lock/Unlock
Storage Temperature
-40 ~ +55℃
⚠Please note that outdated production of the battery you use may affect the default battery life.
⚠This lock is not suitable for metal body cabinet or drawer cover
Battery housing
Works with 3 AAA batteries.
The WT-M-1708-00IC is a motorized lock that can be
locked by swiping and unlocked by swiping a card.
Made for drawers and cabinets. If the card is locked
when you read it, it is unlocked. It comes with an
administrator and 1 user card from the factory. Admin
card does not unlock and lock. It is used only for adding
and deleting users cards. Supports 13.56MHz Mifare
cards.
WT-M-1708-00IC! ! /2 3
How to use
The WT-M-1708-00IC comes with an administrator and a user card. Administrator card does not unlock and
lock. It is used only for adding and deleting users cards. Supports 13.56MHz Mifare cards.!
Insert 3 AAA batteries before using them. Try before mounting with the user card. When the card is shown to
the reader side of the lock, the latch is pushed out by the motor. The latch does not enter before the card is
read again.!
Registering and Deleting User Card
It comes with one administrator and one user card.!
1. Registering a User Card!
1.1.Have the administrator card read. You will hear a melody. Then have the card you want to
identified swipe. If you hear a long beep, the card has been identified. It exits card identification
mode within 5 seconds. If you want to identify more than one card, you can read the cards one
after the other. A long beep will sound after each reading.!
⚠Remember that you can identify a total of 21 user cards.
2. Deleting All Cards (Including Administrator Card)!
2.1. You will hear a melody the first time you read the administrator card. Then, if you make the
administrator card read 5 more times, all the cards in the lock memory are deleted. !
3. Setting Up the Administrator Card!
3.1.After all cards are deleted, the first card read to the lock is assigned as the administrator card. !
⚠Card information is not deleted even if you remove the battery. Therefore, you should never lose your
administrator card.
Usage
4.Unlock & Lock!
4.1. Unlock!
"Swipe the card to open your drawer or locker. The motor will pull in the latch. You can now open the
drawer or cabinet. !
4.2. Lock!
"Close the drawer or cabinet door. Have the card read again. The motor will push the latch out and
lock. !
⚠Make sure that the drawer or cabinet door is fully closed. In cases where the latch is prevented from
being pushed out, it automatically retracts the latch.
⚠If the batteries are about to run out, it starts to sound a warning. In this case, you must replace the
battery. The right approach would be to replace the batteries every year, depending on the frequency of
use.
SECURITURK
Document No: S20202K00021
www.securiturk.com!
www.elektronik-guvenlik.com
Table of contents
Other Securiturk Lock manuals
