Seeing Machines MiX interface cable User manual

Page 1 of 4
Installation Instructions
Assembly Name
MiX interface cable
Assembly P/N
N/A –prototype only
Revision History
#
Date
Name
Change Description
1
10 Mar 2017
Jess Benning
First release
Parts
Part
Image
5m USB to RS232 Cable

Page 2 of 4
USB clamp maintenance cover
Cable Tie

Page 3 of 4
Assembly Steps
Step Details
Step Image
1. Remove existing maintenance
panel using a T6 torx
screwdriver
2. Plug in USB end of the USB to
RS232 cable

Page 4 of 4
3. Fit USB clamping maintenance
cover.
4. Tighten the cover screws.
Ensure the connector mould is
fitted into the slotted end of the
cover
5. Apply cable tie, tighten and cut
Ensure the cable tie is on the
cover side of the barb.
6. Connect to the existing MiX
serial cable DB9 connector S3
and tighten the screws
7. Assembly complete