Seers Medical SM3650 User manual

DOC No. 07-017-SM ISSUE 1
SERVICE MANUAL
SEERS 3 Section Mobile
Treatment Couch
Model No.’s: SM3650, SM3660, SM3670

DOC No. 07-017-SM ISSUE 1
1. GENERAL MAINTENANCE.
CONGRATULATIONS on the purchase of your SEERS MEDICAL Product. If these service instructions
are adhered too, this product will provide many years of safe and reliable use.
IF THESE SERVICE INSTRUCTIONS ARE NOT FOLLOWED - YOUR WARRANTY COULD BE INVALID!
Always keep these Service Instructions available for reference.
WARNINGS!
Warnings identify potential hazards which if not followed correctly, could result in serious injury, or
possibly even death!
Ensure electric couches are not used in the presence of flammable gasses such as
an anaesthetic agent.
DO NOT EXCEED the Maximum Safe Working Load of 240 Kg (528 lbs) –which
must be distributed evenly across the working surface
Do not concentrate uneven weight on either side of the couch.
When the plug is disconnected, this acts as a disconnect device.
Use only accessories that have been designed or approved for use with this
couch.
Children must not play with the couch at any time.
Adequately supervise children in the proximity of the couch.
CAUTIONS!
Cautions identify circumstances which if not followed correctly, could result in failure or damage of
the equipment!
SEERS 3 SECTION MOBILE TREATMENT COUCH –SERVICE
INSTRUCTIONS
PAGES
PAGES
PAGES
ALL
ALL
ALL

DOC No. 07-017-SM ISSUE 1
2. CLEANING INSTRUCTION
WARNING!
Disconnect the couch from the mains power supply prior to carrying out any cleaning
or decontaminating.
DO NOT SATURATE PRODUCT
IF PRODUCT GETS SATURATED DURING CLEANING, THIS COULD ACCELERATE
CORROSION, REDUCING PRODUCTS LENGTH OF SERVICE.
General Cleaning:
To get rid of any dust or marks on the surface Vinyl MUST be wiped DAILY with a moist soft cotton
cloth. Visible and loose dirt can be picked up with a vacuum cleaner (Do not use a brush type vacuum)
Use a soapy cotton cloth and gently rub stains with circular movements.
For more stubborn marks a dilute bleach solution can be used 5% Bleach to 95% Water.
Stain Removal:
Blot excess liquid as quickly as possible with a clean 100% cotton white absorbent cloth or sponge. If
necessary use clean warm water. Clean the entire area where the spot occurred on the cushion, arm
etc. Water may dissolve dirt particles and make cleaning easier. Spills that are still moist are the
easiest to remove. Leave to air dry naturally, do not use a hair dryer etc to speed up the drying.
Coffee, tea etc spills:
Use an absorbent white cloth or piece of paper. DO NOT RUB. Allow the stain to be absorbed and
removed from the material surface. Then rub gently with white tissue paper in circular movements to
remove any remaining dampness and residue.
Ink, Ball point pen, Denim, hard stains:
Rub the stain by means of gentle circular movements with tissue dampened with 96°alcohol and
water (1:1) After this rub the surface with gentle circular movement with tissue paper to dry it.
Butter, oil, grease stains:
Wipe excess butter, oil or grease off the surface with a clean 100% Cotton white dry cloth. Use a
soapy cotton cloth and gently rub the stain with circular movements. Use a clean damp cloth to wipe
the area and dry the surface.

DOC No. 07-017-SM ISSUE 1
Chewing gum: Place ice cubes in a plastic bag and apply on the chewing gum. Wait several minutes,
lift the ice bag and remove the chewing gum.
DO NOT USE CHEMICALS, SADDLE SOAP, CLEANING SOLVENTS, FURNITURE POLISH,
OILS, VARNISH, ABRASIVE CLEANERS OR AMMONIA IN WATER.
Frequency of routine couch cleaning will depend on exact application.
Frequency of routine couch cleaning will depend on exact application.
1. Ensure the couch is in a suitable area for cleaning.
2. The couch must be OFF of the wheels.
3. Disconnect from mains power supply if electric model.
4. Control handsets can be wiped over using an alcohol wipe.
5. Prepare a solution of warm water and a neutral detergent.
6. DO NOT SATURATE PRODUCT –This should be a wipe down –not a soaking!
7. Start by cleaning the top surface of the couch, working down onto the frames below, ensuring
to not accidentally activate any of the release levers, or user interface parts.
8. Ensure the couch is dry before re-use.
9. Safely discard of cleaning materials.
10. Wash hands thoroughly.
If DECONTAMINATING the couch then repeat steps above using a dilute Hypochlorite & warm water
mixture (mixed at 10,000ppm) instead of warm water and soap.

DOC No. 07-017-SM ISSUE 1
3. MAINTENANCE
WARNING!
Disconnect the couch from the mains power supply prior to carrying out any
maintenance.
All electrical maintenance should be performed by a suitably qualified person.
BLUE or BROWN wires must not be connected to any earth terminal.
1. A visual inspection should be carried out daily prior to use.
2. Regular servicing should be carried out a minimum of every six months or more frequently if
the couch is in constant use.
3. Routine servicing or repair must only be performed by suitably qualified people.
4. Look for any visual signs of damage. Ensure all nuts, bolts and other fasteners are present and
fitted where expected. If loose (can be undone by hand), re- tighten using suitable tools –but
taking care to not over tighten as this could cause binding, juddering, identifiable by a likely
noise.
5. Upholstery fixings should be checked regularly and tightened if loose. DO NOT USE PRODUCT
IF ANY UPHOLSTERY FIXING SCREWS ARE MISSING!
6. Check hinge pins are secured correctly by the e clips. IF THESE ARE MISSING DO NOT USE
COUCH!
7. Check gas struts operate smoothly and correctly throughout all ranges of movement. The
upholstered section should lock once the release lever is no longer operated.
8. Check hydraulic pump (hydraulic variant only) for smooth operation and any signs of leakage.
ELECTRIC MODELS ONLY
9. On electric models ,check the power cable and air pipes on hand and foot switch controls,
looking for any cuts, abrasions or any other deterioration that may have occurred and replace
if necessary.
10. Ensure that the mains power supply plug is attached securely to the motor.
11. Check mains plug connections are tight and the correct fuse is fitted.

DOC No. 07-017-SM ISSUE 1
4. WARRANTY
SEERS MEDICAL Limited standard terms and conditions apply to this device.
A copy of this is available upon request. This contains full details of warranty terms and does not
affect your statutory rights.
For any further information on this product, regarding spares, warranty, service or maintenance
information, please contact:
SEERS MEDICAL Limited
Kenton Road
Debenham
Suffolk
IP14 6LA
T: [phone]
F: [phone]
E: [e-mail]
W: www.seersmedical.com
© SEERS MEDICAL Limited
Manufactured in the UK by SEERSMEDICAL Limited.
As part of our ongoing development programme SEERS MEDICAL Limited reserves the right to alter or
modify specifications and materials without prior notice.

DOC No. 07-017-SM ISSUE 1
Mobile Wheel Base Assembly
02-1025-AI

DOC No. 07-017-SM ISSUE 1
PARTS LIST
02-1025-AI
ITEM
PART NUMBER
DESCRIPTION
QTY
1
08F-1025-ZZ
Mobile Wheel Base Frame
1
2
06C-4040-SF
40x40 END CAP - Grey
6
3
06C-5030-SF
50 x 30 END CAP Grey
4
4
06H-0201-SF
200mm Directional & Locking Castor
1
5
06H-0200-SF
200mm LOCKING CASTOR
3
6
08L-1025-AB
Large Wheel Hex Bar Link
2
7
08D-1025-AC
Hex Wheel Bar-Drilled
1
8
08C-1025-AB
Hex Wheel Bar - Undrilled
1
9
08F-1031-ZZ
Mobile Base Push Pull Bar
1
10
06W-0600-SF
M6 Form B Washer - BZP
6
11
06B-0620-SF
M6 x 20 Pan Head Pozi Drive Screw
2
12
06N-0600-SF
M6 Nylock 'T' Type Nut - BZP
2
13
06C-0006-SF
M6 NUT CAP
2
14
08F-1004-ZZ
Radius Frame
2
15
06U-8000-SF
Pivot Bush ID 10mm, OD 16mm, 10mm long
24
16
08F-1005-ZZ
Link Bar
2
17
06C-0001-SF
Foot Pedal
2
18
06P-0625-SF
6 x 25mm Seloc Pin Carbon Steel
2
19
06C-5025-SF
50 x 25 END CAP Grey
16
20
08F-1006-ZZ
Motor Mount Bracket
2
21
06W-1000-SF
M10 'B' TYPE FLAT WASHER BZP
20
22
06B-1110-SF
M10 x 110 Hex Head 8.8 BZP
4
23
06B-1085-SF
M10 x 85 Hex Head Bolt 8.8 BZP
4
24
06B-1070-SF
M10 x 70 HEX HEAD BOLT 8.8 BZP
4
25
06B-1060-SF
M10 x 60 HEX HEAD BOLT 8.8 BZP
2
26
06N-1000-SF
M10 NYLOC NUT - BZP
2
27
06C-0010-SF
M10 Plastic Nut Cap -Grey
12
28
06C-1000-SF
10mm Body Plug - Black
2
29
06B-0610-SF
M6x10 Socket Cap Head Set Screw
8
30
06F-0012-SF
12mm Capped Starlock
2

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1

DOC No. 07-017-SM ISSUE 1