Seers Medical ST6557 User manual

03-010-UM ISSUE 1
OPERATING INSTRUCTIONS
SEERS™ Traction Couch
Model No.’s: ST6557, ST6567, ST6557P, ST6567P

03-010-UM ISSUE 1
INDEX
1. GENERAL INFORMATION –WARNINGS & CAUTIONS
2. HOW TO USE –
a. WHEEL SYSTEM
b. ADJUSTABLE FOOT
c. ADJUSTING THE HEIGHT OF THE COUCH
d. ALTERING THE BACKREST ANGLE
e. LOCKING & UN-LOCKING THE SLIDING FRAME
f. TRACTION MOUNT
g. ACCESSORY
3. CLEANING INSTRUCTIONS
4. MAINTENANCE
5. WARRANTY
6. TECHNICAL DATA
SEERS TRACTION COUCH –OPERATING INSTRUCTIONS
PAGES
ISSUE
DATE
ALL
1
28.10.2013

03-010-UM ISSUE 1
1. GENERAL INFORMATION.
CONGRATULATIONS on the purchase of your SEERS MEDICAL Product. If these operating instructions
are adhered too, this product will provide many years of safe use.
IF THESE OPERATING INSTRUCTIONS ARE NOT FOLLOWED - YOUR WARRANTY COULD BE INVALID!
Always keep these Operating Instructions available for reference.
ALL User Interfaces are identified by the DARK GREY COLOUR.
WARNINGS!
Warnings identify potential hazards which if not followed correctly, could result in serious injury, or
possibly even death!
Ensure electric couches are not used in the presence of flammable gasses such as
an anaesthetic agent.
DO NOT EXCEED the Maximum Safe Working Load of 240 Kg (528 lbs) –which
must be distributed evenly across the working surface
Do not concentrate uneven weight on either side of the couch.
When the plug is disconnected, this acts as a disconnect device.
Use only accessories that have been designed or approved for use with this
couch.
Children must not play with the couch at any time.
Adequately supervise children in the proximity of the couch.
CAUTIONS!
Cautions identify circumstances which if not followed correctly, could result in failure or damage of
the equipment!
Attention refer to these Operating Instructions for further information

03-010-UM ISSUE 1
2. HOW TO USE.
a. WHEEL SYSTEM
b. ADJUSTABLE FOOT
CAUTION!
Ensure Wheels are retracted before
adjusting the adjustable foot.
1. Ensure the couch is off of the wheels
2. Adjust the foot by turning clockwise or
anticlockwise until the couch is stable.
3. Secure the foot by tightening the nut until it
locks against the threaded cap.
WARNING!
This Couch is not designed for patient transportation
Ensure Wheels are retracted prior to patient transfer or treatment.
Disconnect the electric lead prior to re-locating the couch, ensuring the lead is not
trapped in the mechanism.
Lever Down = Wheels activated and ON
Lever Down = Wheels retracted and OFF

03-010-UM ISSUE 1
c. ADJUSTING THE HEIGHT OF THE COUCH
Hydraulic Elevation (model’s ST6557)
Electric Elevation (model no. ST6567)
1 Way Hand Switch 1 Way Foot Switch
ELECTRIC PERIMTER FOOT SWITCH (Optional fitted Accessory)
1. To elevate the couch, push the pedal
downwards with your foot. Repeat until
correct height is achieved.
2. To lower couch, raise the pedal
upwards, by putting your toe
underneath the lever, lifting the lever
upwards.
2. To RAISE the couch simply push lightly on
the top face of the Perimeter Bar. Releasing
makes the couch lock at the desired height
1. To LOWER the couch simply push lightly on
the underside of the Perimeter Bar.
Releasing makes the couch lock at the
desired height

03-010-UM ISSUE 1
d. ALTERING THE BACK REST AND FOOT SECTION ANGLE
e. LOCKING & UN-LOCKING THE SLIDING FRAME
1. To unlock sliding frame, rotate the indexed lever anti-clockwise as shown above in pic 1
2. To lock in position, rotate lever clockwise to secure
1. To raise the backrest or foot section,
simply grasp the release lever towards
the upholstery and adjust the backrest
to the angle desired.
2. Releasing the lever automatically locks
the section at that angle.
3. To lower, grasp the lever again, and
lower the backrest or foot section to
the required angle.
4. Releasing the lever automatically locks
the section.
Sliding Frame Open (pic 1)
Sliding Frame Closed
WARNING!
Ensure when using the Pelvic and Thoracic Harnesses, the Sliding Top Frame must
Be released before applying traction.

03-010-UM ISSUE 1
f. TRACTION MOUNT
g. ACCESSORIES - Operating Instructions
COUNTER TRACTION STRAPS (Model No. ST6068 )
Two anchor brackets are provided for securing the thoracic counter traction straps.
The brackets are held into position by tightening the grub screws onto the box section of the table.
The brackets must be fitted with the hole situated in the bar pointing outwards.
The large strap is connected onto the anchor bracket by means of a carbine hook, and the small
strap is connected to the thoracic counter traction harness by means of another carbine hook.
The pelvic belt is then attached to the Traction Machine.
Once connected, feed the large strap through the buckle and pull tight. The patient is then ready for
treatment to begin.
To raise the support table platform, unscrew the height
adjustment clamp positioned on the underside of the traction
platform on the vertical stem.
The Platform will raise to desired height, once at the desired
height, re-tighten the height adjusting clamp to secure.
To lower, release the adjusting clamp by rotating anti-clockwise and
push on the platform to lower to desired height and then re-tighten
the clamp to secure.
To rotate the mount, unscrew the locking lever anti clockwise, until
the mount is free to travel in either direction. Relocate lever into one
of the spare holes until the desired location is achieved.
Tighten locking lever by rotating the lever clockwise to secure.

03-010-UM ISSUE 1
FLEXION STOOL (Model No. ST6069)
CERVICAL SITTING UNIT (Model No. ST6071)
ST
To raise the stool, unscrew the height adjustment clamp
positioned on the underside on the vertical stem.
The stool will raise to desired height, once at the desired
height, re-tighten the height adjusting clamp to secure.
To lower, release the adjusting clamp by rotating anti-clockwise and
push on the stool to lower to desired height and then re-tighten the
clamp to secure.
Locate the Cervical Sitting Attachment into the mounting
bracket located on the backrest of the couch.
Secure in position with the locking lever, by rotating clockwise
into the desired hole.
WARNING!
The Flexion Stool is not designed as a seat and has a maximum load of 35kg.
Only use with the traction table as a support beneath the leg calves.
WARNING!
When not carrying out cervical traction, remove
the locking lever from the couch, so as to not
interfere when using the rolling traction top.

03-010-UM ISSUE 1
3. CLEANING INSTRUCTIONS
Frequency of routine couch cleaning will depend on exact application.
1. Ensure the couch is in a suitable area for cleaning.
2. The couch must be OFF of the wheels.
3. Disconnect from mains power supply if electric model.
4. Control handsets can be wiped over using an alcohol wipe.
5. Prepare a solution of warm water and a neutral detergent.
6. DO NOT SATURATE PRODUCT –This should be a wipe down –not a soaking!
7. Start by cleaning the top surface of the couch, working down onto the frames below, ensuring
to not accidentally activate any of the release levers, or user interface parts.
8. Ensure the couch is dry before re-use.
9. Safely discard of cleaning materials.
10. Wash hands thoroughly.
If DECONTAMINATING the couch then repeat steps above using a dilute Hypochlorite & warm water
mixture (mixed at 10,000ppm) instead of warm water and soap.
WARNING!
Disconnect the couch from the mains power supply prior to carrying out any cleaning
or decontaminating.
DO NOT SATURATE PRODUCT
IF PRODUCT GETS SATURATED DURING CLEANING, THIS COULD ACCELERATE
CORROSION, REDUCING PRODUCTS LENGTH OF SERVICE.

03-010-UM ISSUE 1
4. MAINTENANCE
1. A visual inspection should be carried out daily prior to use.
2. Regular servicing should be carried out a minimum of every six months or more frequently if
the couch is in constant use.
3. Routine servicing or repair must only be performed by suitably qualified people.
4. Look for any visual signs of damage. Ensure all nuts, bolts and other fasteners are present and
fitted where expected. If loose (can be undone by hand), re- tighten using suitable tools –but
taking care to not over tighten as this could cause binding, juddering, identifiable by a likely
noise.
5. Upholstery fixings should be checked regularly and tightened if loose. DO NOT USE PRODUCT
IF ANY UPHOLSTERY FIXING SCREWS ARE MISSING!
6. Check hinge pins are secured correctly by the e clips. IF THESE ARE MISSING DO NOT USE
COUCH!
7. Check gas struts operate smoothly and correctly throughout all ranges of movement. The
upholstered section should lock once the release lever is no longer operated.
8. Check hydraulic pump (hydraulic variant only) for smooth operation and any signs of leakage.
ELECTRIC MODELS ONLY
9. On electric models ,check the power cable and air pipes on hand and foot switch controls,
looking for any cuts, abrasions or any other deterioration that may have occurred and replace
if necessary.
10. Ensure that the mains power supply plug is attached securely to the motor.
11. Check mains plug connections are tight and the correct fuse is fitted.
WARNING!
Disconnect the couch from the mains power supply prior to carrying out any
maintenance.
All electrical maintenance should be performed by a suitably qualified person.
BLUE or BROWN wires must not be connected to any earth terminal.

03-010-UM ISSUE 1
5. WARRANTY
SEERS MEDICAL Limited standard terms and conditions apply to this device.
A copy of this is available upon request. This contains full details of warranty terms and does not
affect your statutory rights.
For any further information on this product, regarding spares, warranty, service or maintenance
information, please contact:
SEERS MEDICAL Limited
3 Wilford Bridge Spur
Melton
Suffolk
IP12 1RJ
T: [phone]
F: [phone]
E: [e-mail]
W: www.seersmedical.com
© SEERS MEDICAL Limited 2012
Manufactured in the UK by SEERSMEDICAL Limited.
As part of our ongoing development programme SEERS MEDICAL Limited reserves the right to alter or
modify specifications and materials without prior notice.

03-010-UM ISSUE 1
6. TECHNICAL DATA
Index
ST6557
ST6558
Configuration
Elevation Control
Hydraulic
Electric
Overall Length (cm)
190
Mid Section Length -
Fixed and Rolling (cm)
19 x 2
Head Length (cm)
64
Foot Section Length (cm)
83
Width (cm)
70
Minimum Height (cm)
49
Maximum Height (cm)
98
Safe Working Load &
Lifting Capacity
240 Kg
Electrical Data
Mains Voltage Input
220-240V 50hz 1100mA
120V 60hz 175VA 2400mA
Control Box Output
29v
29v
Duty Cycle
10 % max. 2min / 18 min
10 % max 2min / 18 min
Mains Plug Fuse Rt (UK)
5.0A x 1
-
IEC 601-1 Classification
Class
Double Insulated
Class 1 Earthed
Type B Equipment

03-010-UM ISSUE 1
SEERS MEDICAL Limited
Kenton Road
Debenham
Suffolk
IP14 6LA
t: [phone]
f: [phone]
e: [e-mail]
w: www.seersmedical.com
© SEERS MEDICAL Limited
The mark on this product demonstrates conformity with the Medical Device Directive 93/42/EEC.