Sena WiFi Docking Station User manual

1 2 3
Sena WiFi Docking Station
Quick Start Guide
17.Nov
Main Unit Holder
microUSB
Connector
LED Indicators
microUSB Power Port
[WiFi Docking Station]
[USB Power and Data Cable] [World Wide USB Wall Charger]
Notice:
Please use the USB Power and Data Cable and the World
Wide USB Wall Charger included in the package or a
compatible third-party microUSB cable (5V and higher than
1A) with the WiFi Docking Station. Do not connect the WiFi
Docking Station to a USB port on your PC.
LED Description
Charging Status
Firmware Upgrade Status
WiFi Status
Charging Status
Disconnected
Charging (Main unit is powered off)
Fully charged
Note:
Charging (Main unit is powered on).
To upgrade the rmware, power off the main unit.
Firmware Upgrade Status
Disconnected or no rmware upgrade available
Upgrading rmware
Firmware upgrade completed
WiFi Status
Disconnected from an WiFi access point
Searching for WiFi access point
Connected to an access point

4
Powering On
• Insert the USB Power and Data Cable into the microUSB
Power Port.
Attaching a Main Unit
Connect the main unit to the microUSB cable and attach it to the
WiFi Docking Station. Before connecting the main unit, power off
the unit.
Note:
If you leave the main unit on when connecting it, the charging
LED on the WiFi Docking Station will blink red slowly. Sena Technologies, Inc.
www.sena.com
Customer Support: support.sena.com
E-mail: [email protected]
Connection Setup
1. Open the 30K Utility App.
2. Click the menu button and select the “WiFi Docking
Station” menu.
Connect your smartphone and 30K via
Bluetooth
1. Turn on the 30K.
2. Set the 30K into pairing mode.
3. Connect your smartphone to the 30K in
the Bluetooth settings menu.
Note: To setup your WiFi Docking Station,
power off the 30K main unit, tap the
menu button in the upper left then
select "WiFi Docking Station".
3. Follow the instructions on the 30K Utility App to connect
your WiFi Docking Station to a WiFi access point.
Note:
To change the WiFi access point, perform the Factory Reset
then repeat the steps above.
Upgrading the Firmware of a Main Unit
The rmware will be upgraded automatically while your main
unit is charging. If you want to manually upgrade the rmware,
change the setting on the 30K Utility App.
Note:
Do not unplug the USB Power and Data Cable from the WiFi
Docking Station while upgrading the rmware. The product
may be damaged.
Factory Reset
If you want to restore the WiFi Docking Station to the factory
default settings, you can easily reset the unit:
1. Locate the pinhole reset button on the unit.
2. Gently insert a paperclip into the hole and tap the Factory
Reset Button with light pressure.
3. The WiFi Docking Station will automatically restart with the
three LEDs on.
Note:
The WiFi Docking Station will be restored to factory default
settings which include the WiFi conguration setup, the
rmware setup and the language setup.
5