SereneLife SLOHT48 User manual

BarTableHeater
SLOHT48
Indicator Light with Remote Control, Control Disco Party Outdoor Heater
with Tempered Glass Table Top
Questions? Issues?
We are here to help!
Phone: [phone]
Email: suppor[email protected]

www.SereneLifeHome.com2www.SereneLifeHome.com2www.SereneLifeHome.com 3
PLEASE MAKE SURE THAT YOU HAVE READ THE MANUAL
CAREFULLY BEFORE USING IT.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed
to reduce the risk of re, electric shock, and injury to persons, including the
following:
1. Read all instructions before using this heater.
2. The unit must be placed with the clearance of 100cm to the wall and 30cm to
the ceiling.
3. This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. If provided, use handles when moving this heater. High temperature,
keep combustible material such as furniture, papers, clothes, curtains at least 3
feet (0.9m) from the front of the heater and away from the side and rear.
4. The unit must be securely placed on a horizontal and at surface.
5. The unit is at high temperature during operation. It keeps hot for a period after
shut down. Potential danger would occur when touching it during this period.
6. Don't place the unit close to curtain and/or other ammable objects.
Otherwise there will be a danger of catching re.
7. Don’t cover the unit with anything during operation or a short time after it's
shut down.
8. Don't wrap the power supply cord on the unit.
9. The unit must be handled with care, and avoid of vibration or hitting.
10. The unit must be securely grounded during operation.
11. When damaged, the unit must be repaired by professional repairing team.
12. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualied persons in order to avoid a hazard.
13. The heater must not be located immediately below a socket-outlet.
14. When assembling, keep clear from any board or ammable material.
15. Do not use this heater with a programmer, timer or any other device that
switches the heater on automatically, since a re risk exists if the heater is
covered or positioned incorrectly.
16. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
17. Children should be supervised to ensure that they do not play with the
appliance.
18. The unit is for household use only. It's not allowed to use in building site,
greenhouses, barn or stable where there's ammable dust.
19. The head of the unit is at high temperature during operation.
Unplug the unit and wait till it's cool before cleaning.
20. This heater is not intended for use in bathrooms, laundry areas and similar
indoor locations. Never locate heater where it may fall into a bathtub or other
water container.
21. Don't use this unit in place where causticity or volatile air exists, i.e. dust,
steam, gas, etc.
22. Don't use this unit as a cloth drier or towel drier.
23. Don’t use this unit as a sauna heater.
24. Don't use this unit as a room heater of heat storing.
25. Don't use this unit in place of animal propagating and raising.
26. Don't use this unit in heating system of hot air centre.
27. Don't immerse this unit into water for cleaning.
28. The unit should be plugged in a socket, which is easily visible and reachable.
29. To avoid potential re hazards, do not run your heater or its electrical cord
under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange the
electrical cord away from trac areas and where it will not be tripped over.
30. To disconnect heater, turn controls to o, then remove plug from outlet.
31. Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause re, electric shock, or injury to persons.
32. Always plug heaters directly into a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap(outlet/power strip) because the
extension cord may overheat and cause a risk of re.
33. Surface temperatures become very hot when operating heater. Children and
adults should stay away to avoid burns or clothing ignition.

Fig. A Fig. B
Fig. C
www.SereneLifeHome.com2www.SereneLifeHome.com4www.SereneLifeHome.com 5
34. Young children should be carefully supervised when they are in the area of
the heater.
35. Extreme caution is necessary when any heater is used by or near children or
invalids and whenever the heater is left operating and unattended.
36. Always unplug heater when not in use.
37. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Discard heater,
or return to authorized service facility for examination and/or repair.
38. Do not use outdoors.
39. Connect to properly grounded outlets only.
40. Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or re, or damage the heater.
41. To prevent a possible re, do not block air intakes or exhaust in any manner.
Do not use on soft surfaces, like a bed, where openings may become blocked.
42. A heater has hot and arcing or sparking parts inside. Do not use it in areas
where gasoline, paint, or ammable liquids are used or stored.
CAUTION: EXTEND OR UNFOLD LEGS BEFORE OPERATING.
ATTENTION:
ÉTENDRE OU DÉPLIER LES PATTES AVANT DE METTRE L’APPAREIL EN MARCHE.
SAVE THESE INSTRUCTIONS
PREPARATION
1. Unpack the carton. Take out the accessories pack from the carton of the heater
body. Make sure the accessories listed in the above Accessories Check List are
included. If anything missing, ask the retailer immediately to provide it to you.
2. Prepare a cross head screw driver.
3. Read this instruction manual carefully before installation and use. Keep this
instruction manual in a proper and safe place for future use in case needed.
PARTS DESCRIPTIONS:

www.SereneLifeHome.com2www.SereneLifeHome.com6www.SereneLifeHome.com 7
Accessory Name Qty Accessory Name Qty
Allen Key M8 1 Screw Foot M6*30 2
Allen Key M6 1 Washer 2
Screw M6*20 2 Screw M6*8 4
Wheel 2 Screw M8*120 3
S/S Tube 3 Spring Washer ø8.5 3
Spring Washer ø6.2 4 Spring Washer ø8.2*ø16 3
Screw M6*12 2
PARTS DESCRIPTIONS:
ACCESSORIES PACK CHECK LIST:
INSTALLATION
1. Take out all the components form the cartons.
2. As shown in gure A, turn over the Base and Base Cover, let Screw M6*12(#5)
x the Wheels(#3) through the small holes on the Base.
3. Fix Screw Feet M6*30(#22) onto the Screw Board, and adjust it into the same
level as the Wheels.
4. Put Spring Washer ø8.5(#24) and Spring Washer ø8.2*ø16(#25) into the Screw
M8*120(#23) then get through the Base(#4), Base Cover(#6), S/S Tube(#26).
Use the provided Allen Key M8 to fasten the Screw M8*120（#23）with Foot Bracket.
5. Turn over the Heater Body. Put the Base on it. Pull out the Power Cord（#9）
through the Base Cover (#6)and Base(#4).
6. Let the Base Brackets(#7)match with the holes on the Base Cover (#6) and
Base (#4). Then x the Base Brackets with the Washers (#2) and Screw M6*20 (#1)
with the provided Allen Key M6.
7. Fix the Power Cord with the Cord Clip (#10).
8. Put Table Top on top of the Heater Body. Make sure the screw holes on Table
Fixture are matching the holes on Top Steel Board. Fix Table Top onto Heater
Body with 4 Screws M6*8 (#15) and Spring Washers ø6.2 (#14)
OPERATIONS:
1. Plug in the unit to a socket. Make sure the power supply is same as rated.
If the heater’s indicator light starts ashing, it means it's in standby status.
2. Press Mode button on the control panel or remote control to switch to low
power or high power as desired. Indicator Light – Green light & Red light will
light up accordingly.
3. Press OFF button on the control panel or remote control to shift the heater to
Standby mode.
GROUNDING INSTRUCTIONS:
This heater is for use on 120 volts. The cord has a plug as shown at A in Figure
below. An adapter as shown at C is available for connecting three-blade grounding-
type plugs to two-slot receptacles. The green grounding lug extending from the
adapter must be connected to a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a three-slot grounded receptacle is
available.
No. Part Name No. Part Name No. Part Name
1 Screw M6*20 11 Table Top 21 Remote Controller
2 Washer 12 Table Fixture 22 Screw Foot M6*30
3 Wheel 13 Top Steel Board 23 Screw M8*120
4 Base 14 Spring Washer ø6.2 24 Spring Washer ø8.5
5 Screw M6*12 15 Screw M6*8 25 Spring Washer ø8.2*ø16
6 Base Cover 16 Control Panel 26 S/S Tube
7 Base Bracket 17 Power Indicator Light 27 Foot Bracket
8 Heater Body 18 OFF Buttom
9 Power Cord 19 Receiver
10 Cord Clip 20 Mode Button
Grounding Methods
Metal Screw
Ground cover
Outlet Box
Grounding Pin
A B
Grounding Pin
Grounding Means
C D
ADAPTER

www.SereneLifeHome.com2www.SereneLifeHome.com8www.SereneLifeHome.com 9
CLEANING:
• Unplug the unit before cleaning. It should be wiped with wet cloth.
• Don't use too much water.
• Any other servicing should be performed by an authorized service
representative.
FEATURES:
• Oers Sun-like Infrared Heating
• Includes Mesh Grille Front
• Odorless, No Gas or Propane Use
• Remote Control Table Heater
• Dust and Waterproof Design
• Multi-function Disco Light with Remote Control
• Anodized Extruded Aluminum Alloy Frame and Control BC
• High-Eciency Carbon Fibre Heating Elements
• Two Power Settings: Low and High
• 360 Degree Tip-over Safety Switch
• IP55 Approved
• Overheat Protection and Quiet Op
WHAT'S IN THE BOX:
• 1500 Watt Electric Patio Heater
• (2) Allen Wrench
• (2) Screw M6 x 20
• (2) Wheel
• (3) S/S Tube
• (4) Spring Washer ø6.2
• (2) Screw M6 x 12
• (2) Screw Foot M6 x 30
• (2) Washer
• (4) Screw M6 x 8
• (3)Screw M8 x 120
• (3)Spring Washer ø8.5
• (3)Spring Washer ø8.2 x ø16
• (1) Remote Controller
Technical Specs:
• Construction Material: Aluminum Alloy Frame, Tempered Glass,
Stainless Steel Base Cover
• Power Supply: 1500W
• 2 Heat Levels: Low (750 Watts), High (1500 Watts)
• Heating Area: 15 sq. ft.
• Maximum Amperage: 12.5 Amps
• Battery Operated Remote: 1.5V, (2) x ‘AAA’Batteries (not included)
• Power Cable Length: 2 Meters, 120V
• Base Cover Size: 19.68'' -inches (Diameter)
• Heat Warm Range: Around 10-15 Square Meters
• Table Top Dimension (L x W x H): 23.6''' x 23.6'' x 0.39'' -inches
• Product Dimensions (L x W x H): 23.6'' x 23.6'' x 43.3'' -inches