SereneLife PMTR12 User manual

Outdoor Bug Zapper
User Manual
PMTR12

Precautions
1. Do not move the product when it is working.
2. Do not put your fingers into the Mosquito trap while switched on.
3. When cleaning the product turn off the power firstly.
4. Do not let children touch at any time.
5. If an accident occurs call emergency services.
6. Do not use near water.
Warning:
The appliance is not intended for use by person (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be placed by the manufacture, its service agent or similarly
qualified persons in order to avoid a hazard.
Routine maintenance

How to clean the mosquito trap?
Turn off the switch and pull out the power cable plug before cleaning.
Take out the safety net. Clean the mosquito trap from the bottom to the top.
First turn the base anticlockwise and off load. Take out the screen window
rubber and then pull out the screen window, clean screen window with brush
(Picture 1).
Lay the part (picture 2) breadthwise, unscrew the screws which around the
middle part, and then separating this two parts.
Clean the inside of the middle part and fan with the brush. You may also wipe
them with a piece of wet cloth (Picture 3).
How to replace the light tube?
Lay the top part conversely, turn the light tube turn half, and take out them (Picture 4).
Pull all components under the intake and let them airing naturally. Then
assemble them in reverse way.
Features
Mosquitoes, even in dark, can easily locate where a person is by sensing carbon dioxide and
temperature that he/she sheds.
Also, they react extremely sensitively to near ultraviolet rays.
Using these properties of mosquitoes, photo-catalyst mosquito trap can decoy and capture
mosquitoes both in bright indoors and in dark outdoors by a tripartite system, heat and near
ultraviolet rays produced.

Operation
1. Assemble the seat: Put the cover (2) on the weighting block (1), put the bottom support (4) on
the cover (2), and direct the four holes. Then use the screws (6) to binding the weighting block,
cover and bottom support, and use four nuts (7) to fixing the screws (6). Put the middle support
(10) on the bottom support (4), until click into it, and then put the top support (3) to the middle
support (10), until click into it. Insert the ring (9) to the top support (3), and then fixing them with
screws (8).
1 2 3
4
5 6 7 8 11 9 10
1. Weighting block
2. Cover of weighting block
3. Top support
4. Bottom support
5. Screws for fixing the bottom support and weighting block
6. Nuts for fixing the bottom support and weighting block
7. Screws for fixing the ring
Steps
1. Put the trap into the ring, and fixing the machine and ring with screws
2. Insert the plug to the power supply.
3. Turn the switch on in the power cable, then trap is on.
4. The traps are designed to operate continuously, 24 hours a day.
5. To crease operation just turn off the switch.
6. To empty the trap, first ensure that it is turned off and disconnected from the power source.
Unscrew the unit replace the capture net. Some mosquitoes may still be alive, so cover the trap
with a cloth or tower before removing the capture net.