Shark APEX QS360Q User manual

QS360Q_QSG_MP_Mv2
For questions or to register your product, visit us online at sharkclean.com
@sharkcleaning
Brushroll/Soft Roller Access
1. To open the brushroll garage, slide both
release buttons on the floor nozzle away
from you, towards the back of the nozzle,
then lift o the lid.
2. To close the brushroll garage, insert
the 3 tabs on top of lid into the 3 slots in
the nozzle, then push down on both sides
of lid until it clicks securely into place.
If Brushroll Indicator Light is green and
headlights are flashing, check again that
both sides of lid are locked in place.
MAINTENANCE
Brushroll Maintenance
With the garage lid removed, carefully
clear away any debris that may
be impeding the brushroll.
Cleaning the Soft Roller
Lift out the Soft Roller by pulling the tab
on the right side. Clear away any debris,
then slide the Soft Roller back into place.
Checking the Nozzle for Blockages
Tilt the neck of the nozzle back to straighten
the airway, then remove any blockages.
Empty the dust cup every time
debris reaches the MAX fill line.
Empty
QS360Q
QUICK
START
GUIDE
Register your vacuum at
registeryourshark.com
For additional parts
and accessories, visit
sharkaccessories.com
Please be sure to read the enclosed Shark®Owner's Guide prior to using your unit.
HAVING TROUBLE?
ISSUE
Vacuum is not picking up debris. No suction
or light suction.
Solution
Empty dust cup, clean filters, check all
openings for blockages.
ISSUE
Vacuum lifts area rugs.
Solution
Turn o the unit to disengage the brushroll
and restart with the Power button.
NOTE: If you see any hair wrapped
around the brushroll, continue cleaning,
using Setting II, Carpet, on bare floors.
This will allow the self-cleaning brushroll
to remove the hair wrap and send it to
the dust cup.
© 2020 SharkNinja Operating LLC. APEX, DUOCLEAN, and SHARK are registered trademarks
of SharkNinja Operating LLC.
APEX®
Corded Stick Vac with
Self-Cleaning Brushroll

VERSATILE FLOOR-TO-CEILING CLEANING
DUOCLEAN® TECHNOLOGY
STORAGE
ASSEM B LYWHAT’S INSIDE:
UPRIGHT MODE
To clean floors, step on the floor nozzle
and tilt the handheld vacuum back.
ABOVE-FLOOR WITH WAND
Stand the vacuum upright. Step on
the foot pedal on the bottom left side
of the floor nozzle and pull the wand
up to disconnect it. Great for cleaning
baseboards, ceiling fans, window sills, etc.
ABOVE-FLOOR
WITH HANDHELD
Press the Wand
Release button and
lift the handheld
vacuum o the wand.
Great for cleaning
stairs and furniture.
Setting I: Bare Floor/Small Area Rugs
Gentle on bare floors and
small area rugs.
The brushrolls will
spin slowly to help
with debris pickup.
ON FLOORS
Direct engagement with the Soft Roller
removes large particles, small particles,
and stuck-on dust. Slide the power
switch to position I for Bare Floor/Small
Area Rugs, or II for Carpets. To turn o
power, slide the switch to O.
ONBOARD HOOK
Hang the handheld vacuum on the hook
on the bottom of the wand, and wrap
the power cord around the cord hooks.
ON CARPETS*
The Soft Roller pulls in large particles,
while the deep-cleaning brushroll
removes embedded fine dirt.
*For deep cleaning per ASTM F 608 (embedded dirt in carpet) please use Setting II, Carpet.
Setting II: Carpet
Optimized brushroll speed for carpets.
The brushrolls
will spin faster
to help pick up
debris below
the surface.
AHandheld
Vacuum
BMotorized Floor
Nozzle
CWand
DCrevice Tool
EPet Multi-Tool
FOnboard
Storage Clip
GPrecision Duster
HUnder-Appliance
Wand
A
D E F
G
H
B C
(Click)
(Click)
1 2
NOTE: All accessories are compatible with both the wand and the
handheld vacuum. Use Setting I, Bare Floor/Small Area Rugs, with
all above-floor accessories.
NOTE: Wrap the power cord around the top hook first,
leaving a little slack while wrapping.