Shark Navigator Swivel Pro Complete User manual

Remove dust cup to access foam
and felt filters. To remove HEPA
filter, press down on top of filter
door, then tilt and lift out door.
Press tab at top of HEPA filter and
pull out filter.
To reinstall, insert HEPA filter into
unit and replace the filter door.
Rinse foam and felt filters every
month to keep the suction strong.
Rinse HEPA filter every year.
Rinse filters with water only and allow them to air-dry
completely before reinstalling. Between washes, tap loose
dirt from filters as needed.
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
ASSEMB LY
AVacuum Pod
BHandle & Hose
CWand
DHose Holder
E5.5" Crevice Tool
FDusting Brush
GUpholstery Tool
WHAT’S INSIDE EMPTYING THE DUST CUP
MAINTENANCE
QUICK START GUIDE
Empty the dust cup after each use.
clean
A
BC
F
G
D
E
Brushroll access
Unlock Open Cover Clear Intake
Use a coin to turn the locks counterclockwise until they click
open, then lift the cover to access the brushroll. Clear the
debris intake.
(Click)
(Click)
(Click)
(Click)
NOTE: For proper operation, ensure all parts
are firmly CLICKED into place.
SWIVEL PRO COMPLETE
HEPA
Filter
Filter
Door
Foam
Felt

2 WAYS TO CLEAN
FLOOR CLEANING
ABOVE-FLOOR CLEANING
For additional information or to register your product, visit us online at sharkclean.com
@sharkcleaning
OR
HARD FLOOR
Press switch to I for
hard floor surfaces.
CARPET
Press switch to II
for low and high pile
carpet cleaning.
Attach a cleaning
accessory to handle
or wand.
For additional parts and accessories, visit sharkaccessories.com
OR
To clean above-floor areas, remove
the handle from the wand. Or for more
reach, remove the wand from the pod.
1
1 2
2 3
To engage brushroll, step on floor
nozzle and tilt handle back.
© 2019 SharkNinja Operating LLC NV150_QSG_MP_Mv1