Shark NV36A series User manual

Owner’s Guide
www.sharkclean.com
NV36 Series
NV36_NV36A_26_IB_ENG_110421_1.indd 1 11-04-29 9:51 AM

TOLL FREE: 1-800-798-7398
This manual covers model numbers:
NV36 26
NV36A 26
TECHNICAL SPECIFICATIONS
Voltage: 120V.
Watts: 1200W
Amps: 10A
Hertz: 60Hz
NV36_NV36A_26_IB_ENG_110421_1.indd 2 11-04-29 9:51 AM

TOLL FREE: 1-800-798-7398
1www.sharkclean.com
Contents
Important Safety Instructions 2
Getting Started 4
Using the Vacuum 6
Cleaning with the Vacuum Accessories 7
Emptying the Dust Cup Assembly 8
Proper Care of Your Vacuum 9
Troubleshooting 10
Checking for Blockages 11
Maintenance 12
Warranty and Registration 13
Thank you for
purchasing
the Shark®
Navigator™
Upright Vacuum.
NV36_NV36A_26_IB_ENG_110421_1.indd 1 11-04-29 9:51 AM

2 TOLL FREE: 1-800-798-7398
WARNING:
TO REDUCE THE RISK OF ELECTRIC
SHOCK OR INJURY DO NOT USE
OUTDOORS OR ON WET SURFACES.
WHEN USING YOUR SHARK® NAVIGATOR™
UPRIGHT VACUUM, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
YOUR SHARK® NAVIGATOR™ UPRIGHT
VACUUM.
POLARIZED PLUG:
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature, this
plug will fit into a polarized outlet only one way.
Do not force into the outlet or try to
modify the plug to fit.
GENERAL ELECTRICAL SAFETY:
1. Unplug from electrical outlet when not in use
and before servicing.
2. DO NOT use vacuum with a damaged cord or
plug.
3. DO NOT pull or carry vacuum by the cord.
4. DO NOT unplug by pulling on cord; to unplug,
grasp the plug, not the cord.
5. DO NOT handle plug or vacuum cleaner with
wet hands.
6. DO NOT run the vacuum over the power cord.
7. DO NOT close a door on the cord.
8. DO NOT pull cord around sharp corners.
9. DO NOT leave appliance when plugged in.
10. Keep power cord away from heated surfaces.
11. Turn off all controls before plugging or
unplugging vacuum cleaner.
12. Always turn off this appliance before connecting
or disconnecting the motorized nozzle
HOSE ATTACHMENTS:
13. DO NOT use if air flow is restricted; if the air
paths, the hose or the extension tube become
blocked, turn the vacuum cleaner off. Remove
all obstructions before you turn on the unit
again.
14. Keep the end of the hose, wands and other
openings away from face and body.
15. Keep rotating brush and suction openings away
from hair, face, fingers, uncovered feet or loose
clothing.
16. Only use manufacturer’s recommended
attachments.
IMPORTANT SAFETY INSTRUCTIONS
For Household Use Only
NV36_NV36A_26_IB_ENG_110421_1.indd 2 11-04-29 9:51 AM

TOLL FREE: 1-800-798-7398
3www.sharkclean.com
GENERAL USE:
17. Use only as described in this manual.
18. DO NOT put any objects into openings.
19. Keep your work area well lit.
20. Keep the vacuum moving over the carpet
surface at all times to avoid damaging the
carpet fibers.
21. DO NOT place vacuum on unstable surfaces
such as chairs or tables.
22. DO NOT allow young children to operate the
vacuum or use as a toy.
23. DO NOT use vacuum cleaner if it has been
dropped, damaged, left outdoors or submerged
in water. Return to EURO-PRO Operating LLC
for examination, repair or adjustment.
CYCLONIC CHAMBER/DUST CUP/FILTERS:
24. Before turning on the vacuum:
• Make sure that dust cup, cyclonic chamber
and all filters are in place after routine
maintenance.
• Make sure that all components and filters are
thoroughly dry after routine cleaning.
• Only use filters and accessories provided by
EURO-PRO Operating LLC [Failure to do so
will void the warranty].
GENERAL CLEANING:
25. DO NOT run the vacuum over large-sized
objects.
26. DO NOT pick up hard or sharp objects such as
glass, nails, screws or coins that could damage
the vacuum cleaner.
27. DO NOT pick up smoking or burning objects
such as hot coals, cigarette butts or matches.
28. DO NOT pick up flammable or combustible
materials such as lighter fluid, gasoline,
kerosene or use in areas where they may be
present.
29. DO NOT pick up toxic solutions such as
chlorine bleach, ammonia or drain cleaner.
30. DO NOT use in an enclosed space where
vapors are present from paint, paint thinner,
moth-proofing substances, flammable dust or
other explosive or toxic materials.
31. DO NOT vacuum up any liquids.
32. DO NOT immerse vacuum cleaner in water or
other liquids.
33. DO NOT use outdoors or on wet surfaces; use
only on dry surfaces.
34. Use extra care when cleaning on stairs.
SAVE THESE
INSTRUCTIONS
NV36_NV36A_26_IB_ENG_110421_1.indd 3 11-04-29 9:51 AM

4 TOLL FREE: 1-800-798-7398
FIRST THING’S FIRST, YOU
NEED TO KNOW WHAT’S IN THE
BOX YOU JUST OPENED:
A Vacuum Body
B Floor Power Nozzle
C Handle Assembly
D Super Stretch Hose
E Cleaning Wand
F Pet Hair Power Brush
G Cleaning Attachments
H 24” Crevice Tool
I Extended Reach Kit
J Accessory Bag (not shown)
* Note: Optional tools are available for sale
for any NV36 model: 1-800-798-7398.
Getting Started
Your Shark® Navigator™
Upright is easy to assemble:
1 Lay your vacuum body on a
level surface.
2 Slide the electrical connection
from the power nozzle into the
main body to click into place.
3 Connect the hose from the main
body to the power nozzle; push
with a slight turning motion to
create a snug fit.
4 Slide the handle assembly
into the upright unit aligning
the hose hook on the handle
assembly with the power cord
hooks on the back of the unit.
5 Secure the handle assembly in
place with included nut/bolt
(shipped attached to handle
assembly).
6 Place the vacuum in the upright
position.
7 Store the Crevice Tool, Dusting
Brush and Cleaning Wand on
the unit.
A C E
4
5
3
7
2
G
H
B
F
D
I
NV36_NV36A_26_IB_ENG_110421_1.indd 4 11-04-29 9:51 AM

TOLL FREE: 1-800-798-7398
5www.sharkclean.com
IMPORTANT:
For suction to reach the Floor
Power Nozzle, the Cleaning
Wand and Super Stretch Hose
must be attached securely on
the vacuum body.
10 To carry the vacuum:
With the unit in the standing
position, lift by the Dust Cup
Handle.
CAUTION: When lifting or
carrying, DO NOT press Dust
Cup Assembly release button.
8 Attach the Super Stretch Hose:
a) Snap hose into swivel
connector
b) Route under anti-tip hook
c) Route over upper hose
holder
d) Press securely onto cleaning
wand
IMPORTANT:
To prevent vacuum from
tipping, secure hose under the
anti-tip hose hook.
9 To store the vacuum:
When storing your vacuum,
wind the cord around the two
cord holders and secure with
cord clip:
• Quick Cord release at the
top of the unit – place in the
upright position.
• Cord holder near the base –
turn it until it is pointing down.
To release the cord, turn the Quick
Cord release to the left or right.
Store the Extended Reach Kit,
the Pet Hair Power Brush and
the 24" Crevice Tool in the
accessory bag when not in use.
c
8 9
d
b
a
NV36_NV36A_26_IB_ENG_110421_1.indd 5 11-04-29 9:51 AM

6 TOLL FREE: 1-800-798-7398
Using the Vacuum
Your Shark® Navigator™ Upright
Vacuum can be used to clean bare
floors or carpets – with the click of
a switch.
Stand the vacuum into the upright
position.
Plug in the vacuum.
1 Start with the Power Switch in
the “O" - Off position.
2 Place your foot on the Floor
Power Nozzle and pull handle
towards you.
3 Set the Power Switch to desired
cleaning setting.
4 When cleaning carpets:
Ensure you have pulled the
handle towards you and select
the “II" - Brushroll On position
to agitate the carpet fibers for
deeper cleaning performance.
When cleaning bare floors:
Select the "I" - On position for
suction only cleaning to avoid
scattering dirt while cleaning.
IMPORTANT:
Your Brushroll Indicator Light
will illuminate solid green when
the brushroll is on, or solid red if
there is a blockage. This feature
is designed to protect your
Lifetime Belt that powers your
brushroll. See Checking for
Blockages on page 11.
NOTE: The height of your power
nozzle has been optimized
for easy pushing and superior
cleaning on all floor types, so
there is no need to make any
height adjustments as you
transition to different floor &
carpet types.
Indicator Light
1
4
OFF
Bare Floors / Tools
Carpets
IMPORTANT: To protect your
carpets, the brushroll will only
turn on when you have pulled
the handle back towards you and
released the Floor Power Nozzle.
NV36_NV36A_26_IB_ENG_110421_1.indd 6 11-04-29 9:51 AM

TOLL FREE: 1-800-798-7398
7www.sharkclean.com
Cleaning with the Vacuum Accessories
Before cleaning with your
accessories:
Stand vacuum into upright position.
Secure Super
Stretch Hose in
the anti-tip hose
hook to prevent
tipping.
Select the “I" - On position for
suction only cleaning.
DO NOT pull vacuum cleaner
around by the hose.
DO NOT overextend the hose.
Vacuum Accessories
Your vacuum comes with a Super
Stretch Hose and Cleaning Wand.
Use one or the other to attach your
cleaning accessories.
1 Using the Super Stretch Hose:
Stand the vacuum into upright
position.
Remove the hose from the
Cleaning Wand.
Push the selected tool into the
hose connector.
1
3
456
2
3
456
2 Using the Cleaning Wand:
Stand the vacuum into upright
position.
Remove the Cleaning Wand
(with hose attached) from the
unit.
Push the selected tool into the
end of the Cleaning Wand.
3 Pet Hair Power Brush
4 Dusting Brush
5 Crevice Tool
6 24” Crevice Tool
Extended Reach Cleaning Kit
Includes an extra Cleaning Wand and
extra Super Stretch Hose.
Increases your cleaning
reach to over 27 feet!
To order additional parts and accessories,
go to www.sharkclean.com or call
1-800-798-7398.
Extended Reach
Cleaning Kit
NV36_NV36A_26_IB_ENG_110421_1.indd 7 11-04-29 9:51 AM

8 TOLL FREE: 1-800-798-7398
Maintenance
For best results empty the Dust Cup
after each use; empty several times
during prolonged usage. or when it
reaches the MAX fill line.
NEVER OVER-FILL THE DUST
CUP.
Stand vacuum into upright position.
Turn vacuum off.
To empty the Dust Cup:
1 Grip carry handle and press
the Dust Cup release button to
remove.
2 Option A: For Quick Empty:
Insert Dust Cup deep inside
trash receptacle to contain dust
and debris.
Press the bottom Dust Cup
release button; tap container
gently to dislodge and release
dust and debris.
Snap door in place.
Important: If the Dust Cup
Door does not swing open after
pressing the release button,
push the door open using the
bottom door tabs.
CAUTION:
Unplug the vacuum;
failure to do so might
result in electric
shock.
3 Option B: For Allergy Sufferers:
Wrap a trash bag around the
Dust Cup leaving space at the
bottom for the door to swing
open.
Locate the Dust Cup Door
release button within the trash
bag and press to release as you
shake the dust cup to empty
dust and debris.
Snap the bottom door in place.
Note: Option B can also be per-
formed outside of the home to
further minimize releasing dust
back into the air. Carry just the
Dust Cup and trash bag outside.
Note: Some dust and debris
may remain in the top of your
dust cup on or near the metal
screen. It is not necessary to
completely remove this material
before continuing to vacuum;
Shark® advanced cyclonic action
will sweep the metal screen
clean once you begin to refill
your dust cup.
1 2 3
NV36_NV36A_26_IB_ENG_110421_1.indd 8 11-04-29 9:51 AM