Sharp EL-2901RC User manual

EL-2901RC
ELECTRONIC PRINTING CALCULATOR
DRUCKENDER TISCHRECHNER
CALCULATRICE IMPRIMANTE ÉLECTRONIQUE
CALCULADORA IMPRESORA ELECTRÓNICA
CALCOLATRICE ELETTRONICA STAMPANTE
ELEKTRONISK SKRIVANDE OCH VISANDE RÄKNARE
ELEKTRONISCHE REKENMACHINE MET AFDRUK
CALCULADORA ELETRÔNICA COM IMPRESSORA
ELEKTRONISESTI TULOSTAVA LASKIN
SZALAGOS ASZTALI KALKULÁTOR
OPERATION MANUAL
BEDIENUNGSANLEITUNG
MODE D’EMPLOI
MANUAL DE MANEJO
MANUALE DI ISTRUZIONI
BRUKSANVISNING
GEBRUIKSAANWIJZING
MANUAL DE INSTRUÇÕES
KÄYTTÖOHJE
HASZNÁLATI ÚTMUTATÓ
ENGLISH ............................................................... Page 2
CALCULATION EXAMPLES ................................. Page 82
DEUTSCH .............................................................. Seite 10
RECHNUNGSBEISPIELE ..................................... Seite 82
FRANÇAIS ............................................................. Page 18
EXEMPLES DE CALCULS .................................... Page 83
ESPAÑOL .............................................................. Página 26
EJEMPLOS DE CÁLCULOS ................................. Página 83
ITALIANO .............................................................. Pagina 34
ESEMPI DI CALCOLO ........................................... Pagina 84
SVENSKA .............................................................. Sida 42
RÄKNEEXEMPEL .................................................. Sida 84
NEDERLANDS ...................................................... Pagina 50
REKENVOORBEELDEN ....................................... Pagina 85
PORTUGUÊS ........................................................ Página 58
EXEMPLOS DE CÁLCULO ................................... Página 85
SUOMI ................................................................... Sivu 66
LASKENTAESIMERKKEJÄ ................................... Sivu 86
MAGYAR ............................................................... Oldal 74
SZÁMÍTÁSI PÉLDÁK ............................................. Oldal 86
EL-2901RC(AGO)-Cover-1 03.7.16, 1:35 PM1

EL-2901RC(AGO)-Cover-2 03.7.16, 1:36 PM2

1
Caution!
The socket outlet shall be installed near the equipment and shall be easily accessible.
Vorsicht!
Die Netzsteckdose muß in der Nähe des Gerätes angebracht und leicht zugänglich sein.
Attention!
La prise de courant murale doit être installée à proximité de l’appareil et doit être facilement
accessible.
Aviso!
El tomacorriente debe estar instalado cerca del equipo y debe quedar bien accesible.
Attenzione!
La presa della corrente deve essere installata in prossimità dell’apparecchio ed essere
facilmente accessibile.
Observera!
Anslut till ett vägguttag som återfinns nära enheten och är lätt åtkomligt.
Let op!
Het stopcontact moet in de buurt van het apparaat zijn en ook gemakkelijk toegankelijk zijn.
Atenção!
A tomada elétrica deve estar perto do equipamento e ser de fácil acesso.
Huomautus!
Pistorasia tulee asentaa laitteen lähelle paikkaan, jossa sen käyttöä on helppoa.
Figyelem!
A kalkulátort úgy érdemes elhelyezni, hogy a hálózati csatlakozó aljzatot könnyen el lehessen
érni.
EL-2901RC(AGO)-IEC950 03.7.16, 1:36 PM1

2
CONTENTS
OPERATIONAL NOTES
ENGLISH
Page
• OPERATING CONTROLS ................................ 3
• INK ROLLER REPLACEMENT ......................... 5
• PAPER ROLL REPLACEMENT ........................ 6
• ERRORS ........................................................... 7
• SPECIFICATIONS ............................................. 8
• IN CASE OF ABNORMAL CONDITIONS ......... 9
• CALCULATION EXAMPLES ........................... 82
• EURO CONVERSION ..................................... 96
• COST / SELL / MARGIN CALCULATION ....... 99
To insure trouble-free operation of your SHARP
calculator, we recommend the following:
1. The calculator should be kept in areas free from
extreme temperature changes, moisture, and
dust.
2. A soft, dry cloth should be used to clean the
calculator. Do not use solvents or a wet cloth.
3. Since this product is not waterproof, do not use
it or store it where fluids, for example water, can
splash onto it. Raindrops, water spray, juice,
coffee, steam, perspiration, etc. will also cause
malfunction.
4. If service should be required, use only a SHARP
servicing dealer, a SHARP approved service
facility or SHARP repair service.
5. If you pull out the power cord to cut electricity
completely, the presently stored exchange rate
will be cleared.
6. Do not wind the AC cord around the body or
otherwise forcibly bend or twist it.
SHARP will not be liable nor responsible for any
incidental or consequential economic or
property damage caused by misuse and/or
malfunctions of this product and its peripherals,
unless such liability is acknowledged by law.
EL-2901RC(AGO)-Eng 03.7.17, 3:40 PM2

3
OFF •P P•IC ON
POWER SWITCH; PRINT / ITEM
COUNT MODE SELECTOR:
“OFF”: Power OFF
“•”: Power ON. Set to the non print mode.
“P”: Power ON. Set to the print mode.
“P•IC”: Power ON. Set to the print and item count
mode.
For addition or subtraction, each time is
pressed, 1 is added to the item counter, and
each time is pressed, 1 is subtracted.
•The count is printed when the calculated
result is obtained.
•Pressing of , clears the
counter.
Note: The counter has a maximum capacity of 3
digits (up to ±999). If the count exceeds the
maximum, the counter will recount from zero.
ROUNDING SELECTOR:
Example: Set Decimal Selector to 2.
4 ÷9 = 0.444 ... , 5 ÷9 = 0.555 ...
OPERATING CONTROLS
Note: The decimal point floats during successive
calculation by the use of or .
If the decimal selector is set to “F”then the answer
is always rounded down ( ).
GT • RATE
SET
GRAND TOTAL / RATE SETTING MODE
SELECTOR:
“GT”: Grand Total
“•”: Neutral
“RATE SET”: Rate setting
•Enter the adding exchange rate, then press .
•A maximum of 6 digits can be stored (decimal point
is not counted as a digit).
•Only one rate can be stored. If you enter a new
rate, the previous rate will be cleared.
F 6 3 2 1 0 A
DECIMAL / ADD MODE SELECTOR:
“6 3 2 1 0”: Presets the number of decimal places
in the answer.
“F”: The answer is displayed in the floating decimal
system.
4 9 5 9
0.45 0.56
5/4 0.44 0.56
0.44 0.55
EL-2901RC(AGO)-Eng 03.7.16, 1:37 PM3

4
“A”: The decimal point in addition and subtraction
entries is automatically positioned to the 2nd
digit from the lowest digit of entry number. Use
of the add mode permits addition and
subtraction of numbers without entry of the
decimal point. Use of , and will
automatically override the add mode and
decimally correct answers will be printed.
PAPER FEED KEY
NON-ADD / SUBTOTAL KEY
CLEAR / CLEAR ENTRY KEY
TOTAL KEY
EQUAL KEY
CHANGE SIGN KEY:
Changes the algebraic sign of a number (i.e.,
positive to negative or negative to positive).
RECALL AND CLEAR MEMORY KEY
RECALL MEMORY KEY
CONVERSION KEY (TO A NATIONAL
CURRENCY)
CONVERSION KEY (TO THE EURO
CURRENCY)
GRAND TOTAL KEY
COST PRICE ENTRY KEY:
Press this key to enter the cost price.
SELLING PRICE ENTRY KEY:
Press this key to enter the selling price.
MARGIN ENTRY KEY:
Press this key to enter the margin.
DISPLAY
Display format:
Symbols:
M: Appears when a number is in the memory.
–:Appears when a number is negative.
•:Appears when a number is in the grand total
memory.
E:Appears when an overflow or other error is
detected.
* Although all available symbols are shown here
for instruction purposes, these symbols will not
appear on the screen simultaneously.
EL-2901RC(AGO)-Eng 03.7.16, 1:37 PM4

5
Cleaning the printing mechanism
If the print becomes dull after long time usage,
clean the printing wheel according to the
following procedures:
1) Remove the printer cover and the ink roller.
2) Install the paper roll and feed it until it comes
out of the front of the printing mechanism.
3) Put a small brush (like a tooth brush) lightly to
INK ROLLER REPLACEMENT
If printing is blurry even when the ink roller is in the
proper position, replace the roller.
Ink roller: Type EA-772R
WARNING
APPLYING INK TO WORN INK ROLLER OR
USE OF UNAPPROVED INK ROLLER MAY
CAUSE SERIOUS DAMAGE TO PRINTER.
1) Set the power switch to OFF.
2) Remove the printer cover. (Fig. 1)
3) Hold the top of the ink roller and remove the roller
by pulling it toward you and then upward. (Fig.
2)
4) Install the new ink roller in the correct position.
Make sure that the roller is securely in place.
(Fig. 3)
5) Put back the printer cover.
Fig. 1 Fig. 2
Fig. 3
EL-2901RC(AGO)-Eng 03.7.16, 1:37 PM5

6
Never insert paper roll if torn. Doing so will
cause paper to jam.
Always cut leading edge with scissors first.
1) Insert the leading edge of the paper roll into the
opening. (Fig. 1)
2) Turn the power on and feed the paper by
pressing . (Fig. 2)
3) Lift the attached metal paper holder up and insert
the paper roll to the paper holder. (Fig. 3)
PAPER ROLL REPLACEMENT
Fig. 1
the printing wheel and clean it by pressing .
4) Put back the ink roller and the printer cover.
Note: •Do not rotate the printing mechanism
manually, this may damage the printer.
EL-2901RC(AGO)-Eng 03.7.16, 1:37 PM6

7
DO NOT PULL PAPER BACKWARDS AS THIS
MAY CAUSE DAMAGE TO PRINTING
MECHANISM.
Fig. 2 Fig. 3
There are several situations which will cause an
overflow or an error condition. When this occurs,
“E”will be displayed. The contents of the memory
at the time of the error are retained.
If an “0䡠E”is displayed at the time of the error, “– –
–––––” will be printed in red and must be
used to clear the calculator.
Also, in rare cases, printing may stop midway and
the indication “E”appear on the display. This is not
a malfunction but is caused when the calculator is
exposed to strong electromagnetic noise or static
electricity from an external source. Should this
occur, press the key and then repeat the
calculation from the beginning.
Error conditions:
1. When the integer portion of an answer exceeds
12 digits.
2. When the integer portion of the contents of the
memory exceeds 12 digits.
(Ex. 999999999999 1 )
3. When any number is divided by zero.
(Ex. 5 0 )
ERRORS
EL-2901RC(AGO)-Eng 03.7.16, 1:37 PM7

8
SPECIFICATIONS
Operating capacity: 12 digits
Power source: AC: 220V–230V, 50Hz
PRINTING SECTION
Printer: Mechanical printer
Printing speed: Approx. 2.1 lines/sec.
(At temperature 25°C
(77°F), when “741.9 + ”is
printed. The printing speed
will vary with the number
of rows and the figure
types to be printed.)
Printing paper: 57 mm (2-1/4") - 58 mm (2-
9/32") wide
80 mm (3-5/32") in
diameter (max.)
Operating temperature: 0°C –40°C (32°F –104°F)
Power consumption: 41 mA
Dimensions: 193 mm (W) ×256 mm (D)
×62.5 mm (H)
(7-19/32" (W) ×10-3/32"
(D) ×2-15/32" (H))
Weight: Approx. 1.0 kg (2.20 Ib.)
Accessories: 1 paper roll, 1 ink roller
(installed), and operation
manual
WARNING
THE VOLTAGE USED MUST BE THE SAME
AS SPECIFIED ON THIS CALCULATOR.
USING THIS CALCULATOR WITH A HIGHER
VOLTAGE THAN THAT WHICH IS SPECIFIED
IS DANGEROUS AND MAY RESULT IN A FIRE
OR OTHER TYPE OF ACCIDENT CAUSING
DAMAGE. WE ARE NOT RESPONSIBLE FOR
ANY DAMAGE RESULTING FROM USE OF
THIS CALCULATOR WITH A VOLTAGE
OTHER THAN THAT WHICH IS SPECIFIED.
0 1 2 3 4 5 6 7 8 9 . ,
0 1 2 3 4 5 6 7 8 9 . ,
0 1 2 3 4 5 6 7 8 9 . ,
0 1 2 3 4 5 6 7 8 9 . ,
0 1 2 3 4 5 6 7 8 9 . ,
0 1 2 3 4 5 6 7 8 9 . ,
0 1 2 3 4 5 6 7 8 9 . ,
0 1 2 3 4 5 6 7 8 9 . ,
0 1 2 3 4 5 6 7 8 9 . ,
0 1 2 3 4 5 6 7 8 9 . ,
EL-2901RC(AGO)-Eng 03.7.16, 1:37 PM8