Sharp XG-V10XU - Conference Series XGA LCD... User manual

How to Connect a Sharp Projector to a Network
Quick Reference Guide
Applicable Models: XG-V10WU XG-V10XU B.) Set IP Address
XG-V10WM XG-V10XM
NOTE: IP Address is Static - verify with
Quick Reference Guide Sections:
IT / MIS Department.
1.) AN-L10T Installation
2.) Projector Configuration
3.) S.A.P.S. Configuration
1.) Install Lan Card into expansion slot
on A/V connector side of the projector
Refer to Operation Manual - page 5
C.) Set Gateway
Refer to O/M page numbers 2 - 3 for details
There are (4) four items to configure
on the projector menu.
A.) Set ID Number
Refer to Operation Manual - page 6
B.) Set IP Address
C.) Set Gateway
D.) Set Subnet Mask
A.) Set ID Number D.) Set Subnet Mask
Refer to Operation Manual - page 7
Refer to Operation Manual - page 4
2.) Configure Projector Menu
Must be
obtained from
IT / MIS
Department
L:\tekcentr\cactrain\qck_ref.xls 13:18 PM
10/12/2001

How to Connect a Sharp Projector to a Network
Quick Reference Guide
A.) Select Multiple control setting E.) Configure E-Mail Sending Criteria
Refer to Operation Manual - page 8
B.) Set the following fields under the projector
setting menu
Refer to Operation Manual - page 14
ID #
Port
IP Address F.) Configure E-Mail Sender Settings Option
Check use projector
Refer to Operation Manual - page 10 - 11
C.) Set the "Projector Name"
Refer to Operation Manual - page 15
G.) Scan for Network Configured Projector
Refer to Operation Manual - page 12
D.) Insert E-Mail Address in E-Mail Address Book
Refer to Operation Manual - page 16
Refer to Operation Manual - page 14
Any Problems
call 1-888-Go-Sharp
(1-888-467-4277)
3.) Configure S.A.P.S.
L:\tekcentr\cactrain\qck_ref.xls 23:18 PM
10/12/2001