Sharper Image 205980 User manual

Item No. 205980
HEATED INDOOR/OUTDOOR SLIPPERS
Owner’s Guide
Thank you for purchasing the Sharper Image Heated Indoor/Outdoor Slippers.
Please read this guide and store it for future reference.
- 1 -
FEATURES
IDENTIFICATION OF PARTS
• Heated slippers for indoor and outdoor use
• Adjustable temperature control – Low, Medium, and High
• Rechargeable lithium-ion batteries (charger included)
A. Slipper input plugs
B. Control button
C. Battery charger input plugs
D. LED light
OPERATION
1. Remove batteries from box.
2. Plug the battery charger into an outlet.
3. Connect the lithium-ion batteries to the input plugs of
the battery charger. Do not force the plug into the battery.
4. The LED light on the charger will light up in red, indicating
that it is being charged.
5. When the LED light on the charger is green, the battery is
fully charged (may take up to 8 hours).
NOTE: Before using your Heated Indoor/Outdoor Slippers,
the batteries should be fully charged. Failure to fully charge
the batteries prior to their first use may reduce battery life.
A
B
C
D
(CONTINUED ON NEXT PAGE)

- 2 -
CLEANING AND MAINTENANCE
• Always remove batteries from the slippers before cleaning
• Spot clean with a damp cloth or hand wash in cold water with mild detergent
• Hang dry
• Do not twist the garment to prevent damaging the cable
• Do not dry clean or bleach
OPERATION (CONT’D)
6. When fully charged, disconnect the batteries from the charger.
7. Locate the input plugs inside the small pouch on the outside
of each slipper and connect the charged batteries. Place the
batteries into the pouch once connected.
8. Press and hold the control button on the side of each slipper
for three to five seconds, or until the LED light flashes red,
then green, then blue.
9. The LED light on the control button of the slippers will then only
flash red, indicating that the shoes are in pre-heat mode.
10. After approximately five minutes, the light will change to solid
red, indicating the slippers are no longer in pre-heat mode. The temperature can be adjusted
by pressing the control button.
¬ Blue: Low heat – 104 °F with approximate run time of 4-5 hours
¬ Green: Medium heat – 113 °F with approximate run time of 2.5-4 hours
¬ Red: High heat – 122 °F with approximate run time of 2-3 hours
NOTE: Recommended to wear socks inside of the slippers.
11. To turn off the slippers, press and hold the control button for three to five seconds,
or until the LED light turns off.
12. Unplug the batteries when the slippers are not in use. Store batteries inside the pouch
of the slippers.
NOTE: The Heated Indoor/Outdoor Slippers should only be used with the included batteries
and charging cable. Never use the batteries or cable with any other device, regardless of how
similar the plugs may look, feel, or appear to fit or work together.
BATTERY WARNINGS
• Do not use batteries if you notice a change of shape (lumps), overheating when charging,
or if rust or corrosion on the battery connectors is found.
• Charge the batteries regularly (recommended a minimum of once every 3 months).
• Charge between each use. (CONTINUED ON NEXT PAGE)

- 3 -
• Maintain at least 25% of the battery power when not in use. Failure to do this will result
in performance problems and reduced battery life.
• The battery life is 300+ cycles before the battery will diminish in capacity output.
• Lithium-ion batteries provide a diminished capacity output at extreme cold temperatures;
keep the batteries inside the slippers to minimize the impact.
• Do not use on open wounds, sensitive skin areas, or in the presence of poor circulation.
• Check skin frequently during use to ensure rashes or burns are not developing.
• The FDA and CPSC recommend the following precautions be taken to avoid hazards associated
with the use of heated clothing:
ALWAYS
• Inspect the slippers before each use to assure they are in proper working order.
• Discard if they look worn or cracked, or if the electrical cord is frayed.
• Read and follow all instructions prior to use.
SAFETY WARNINGS
NEVER
• Use on an infant.
• Use on a person who is paralyzed or has skin that is not sensitive to temperature changes.
• Use on a sleeping or unconscious person.
• Use in an oxygen enriched environment or near equipment that stores or emits oxygen.
• Sit on this device.
• Crush this device.
• Unplug this device by pulling its connecting cord.
• Use pins or other metallic fasteners to hold this device in place.
(CONTINUED ON NEXT PAGE)
• Do not submerge product or battery into water while in use.
• Do not cut, puncture or tear into the lining of the product.
• Do not allow the battery to have contact with water or other liquids. If water or liquids enter
the battery interior, immediately disconnect the product from the battery.
Allow the battery to dry completely before use.
• Do not penetrate, strike, short-circuit or disassemble battery.
• Keep all electronic components of your product away from fire and extensive heat.
• Do not leave product unattended while connected to the battery.
• Only use the charger and batteries included with this product.
BATTERY WARNINGS (CONT’D)

WARRANTY/CUSTOMER SERVICE
Sharper Image branded items purchased from SharperImage.com include a 1-year limited
replacement warranty. For Customer Service, please call [phone].
The SHARPER IMAGE® name and logo are registered trademarks.
©Sharper Image. All Rights Reserved.
- 4 -
SPECIFICATIONS
Model 205980
Power 3,600mAh lithium-ion polymer battery
Heating time Up to 5 hours
Temperature settings Adjustable
Material Polyester, suede
SAFETY WARNINGS (CONT’D)
• If you experience any discomfort while using this product, remove it immediately and consult
your physician before resuming use.
• Check with your physician if you have heart disease, a pacemaker, diabetes, circulatory
problems, sensitivity to heat, or if you are pregnant or the user is under 13 years of age.