Shido Mf4000-12 User manual

IMPORTANT! PLEASE READ THE INSTRUCTION MANUAL CAREFULLY,

AND OPERATE CORRECTLY ACCORDING TO INSTRUCTION.

WARNING! NEVER ALLOW CLAMPS TO TOUCH TOGETHER OR CONTACT

THE SAME PIECE OF METAL.

◎ Do not charge the Jump Starter in dangerous places, such as near fuel, near

fire etc.

◎ Do not expose the Jump Starter to the sun, rain or snow.

◎ Do not place the Jump Starter in microwave oven, pressurized container or

vacuum chamber.

◎ Do not charge the Jump Starter with non-standard charger, use only specified

charger equipped with Jump Starter.

◎ Do not immerse the Jump Starter in water or rinse by water, no waterproof

design.

◎ Do not operate the jump starter if it has received a sharp blow, been dropped

or otherwise damaged in any way.

Charged by DC adaptor (Cigarette charger)

while driving

◎ Plug the DC adaptor into Jump starter's

charging port;

◎ Connect the DC adaptor to the vehicle’s

cigarette outlet, the LED lights flash in the loop;

◎ Five LED lights on when the internal battery fully

charged, Jump Starter will stop charging circuit

automatically;

◎ Disconnect the DC adaptor from the cigarette

outlet, and then unplug the DC adaptor from the

Jump Starter.

MODEL: HJMF4000-12

READ THE INSTRUCTION MANUAL COMPLETELY BEFORE USING THIS PRODUCT.

RETAIN THIS INSTRUCTION FOR FUTURE REFERENCE

INSTRUCTION MANUAL

SMART LITHIUM

SAFETY

GUARANTEED

LiFePO4

Lithium Jump Starter and DC Power Source

• 1 •

CONTENTS

1. WARNING

• 2 •

Product Feature

1.Jump Starter

2. High Power LED Light

3.15V/1A Input port

4. Battery Capacity Indicator

5. POWER/LIGHT Button

6. Jumpstart socket

7. USB DC 5V/2.1A Outlet

8. Waterproof Bag

9. AC charger

10. DC adaptor(optional)

11. 5V USB/Micro USB Connector

(optional)

12. Jump Cable and Clamps

(with fuse)

2. PRODUCT FEATURE

• 3 •

NOTE

◎ Please wait for 10 mins if several fail attempts, then start the vehicle again.

◎ If the vehicle couldn’t be started within 5S, let the Jump Starter cool for 3 mins

before attempting to start the vehicle again, or you may damage the Jump

Starter.

◎ If the ambiance temperature is below -10℃, the cranking performance will

decrease sharply, the Jump Starter may not start the vehicle successfully. You

can try a few attempts to start for warm up the battery and then increase the

starting performance.

◎ If not successful, place the Jump Starter in a warmer area for a short time.

3. OPERATING INSTRUCTION

• 4 •

3.2 USING USB DC5V/2.1A OUTLET

The Jump Starter is a DC power source for all DC devices that are equipped with

a USB plug.

1. Press the <POWER/LIGHT> button to turn on the Jump Starter.

2.P lug the USB switch cable into the USB Outlet.

3.P lug the other end (Micro USB) of the cable into your device or use the

original charging cable of your device. Turn device on, if necessary.

4.W hen finished, turn off the device (if necessary) and unplug the device.

5. Press the <POWER/LIGHT> for 3S to turn off the unit or wait for 30s then the

Jump Starter will shut down automatically.

6.R echarge the Jump Starter immediately after unplugging the device.

NOTE

Electrical devices must be removed first, or the Jump Starter can not shut down

automatically.

3.3 USING HIGH POWER LIGHT

1. Press <POWER/LIGHT> button to turn on the Jump Starter.

2. Quick press <POWER/LIGHT> button to switch three different LED light

modes.

First: Highlight; Second: strobe; Third: SOS; Fourth: Off

3. Press <POWER/LIGHT> for 3S to turn off the Jump Starter.

4. CHARGING THE INTERNAL BATTERY

IMPORTANT! CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH

USE AND EVERY 6 MONTHS, ALWAYS KEEP THE INTERNAL BATTERY

FULLY CHARGED.

Charged by AC charger

◎ Plug the AC charger into Jump Starter's

charging port;

◎ Connect the AC charger to a 100~240VAC

electrical wall outlet, the LED lights flash in the

loop;

◎ Five LED lights on when the internal battery

fully charged, Jump Starter will stop charging

circuit automatically;

◎ Disconnect the AC charger from the AC outlet,

and then unplug the AC charger from the Jump

Starter.

PROBLEM POSSIBLE CAUSE REMEDIES

5. TROUBLESHOOTING

The vehicle can not be

jumpstarted

The device can not be powered

Can not turn on the Jump

Starter

1) Improper clamp connections

2) The switch cable and

connectors are defective

3) The internal battery capacity is

too low

4) The device of 12V to be

powered is over 120W

The internal battery capacity is

too low

1) Check and make sure the connections is correct

2) Check the internal battery capacity and recharge it if

necessary

3) Try starting serval times to warm up the battery and then

the starting performance increase.

1) Check and make sure the connections are correct

2) Change a new switch cable and connectors

3) Check the internal battery capacity and recharge it if

necessary

4) Make sure the device to be powered is not over 120W

Check the internal battery capacity and recharge it if

necessary

6. MAINTENANCE AND CARE

Fuse Protection

Overcharge and

Overdischarge Protection Against-reverse Plug

• 5 • • 6 • • 7 •

7. SPECIFICATION

Battery type 12V 12WH Lithium Iron Battery

15V 1 A and DC / .0 AC charger adaptor (Cigarette charger)

Charger

USB DC 5V 2.1A (Max 2.5A)

Peak Amps: 200A

High Power LED Light (1W)

12AWG/8.58" (21.8cm)

5.6"

×3.1"×1.1" (

142mm*80mm*28mm)

0.7 bls(330g)

Size and length of

Jump Сable and Сlamps

Function

The dimension of

Jump Starter

Weight

The working

temperature

14℉~140℉ (-10℃-60℃)

Fig.1 Fig.2 Fig.3 Fig.4 Fig.5

911

810

◎ Do not attempt to disassemble, modify, knock and throw the product, please

contact your local distributor if the product has any problem.

◎ Never place the Jump Starter directly above battery being jumped

◎ Keep out of reach of Children.

1. WARNING .....................................................................................02~03

2. PRODUCT FEATURE ...........................................................................03

3. OPERATING INSTRUCTION ...........................................................04~05

3.1 JUMPSTART THE VEHICLE ................................................................04

3.2 USING USB DC5V/2.1A OUTLET .... .....................................................05

3.3 USING HIGH POWER LIGHT ...............................................................05

4. CHARGING THE INTERNAL BATTERY ..................................................05

5. TROUBLESHOOTING .........................................................................06

6. MAINTENANCE AND CARE ..................................................................0 6

7. SPECIFICATION .................................................................................07

www.skyrichbattery.com

Power by: Global Power Central Inc

Add: San Gabriel, CA 91776

RoHS

Please read this instruction manual completely

before using this product.

Retain this instruction sheet for future reference.

SHIDO Jumpstarters are distributed by DC AFAM NV, Belgium.

For more info about SHIDO lithium batteries, please visit www.shido-batteries.com

MODEL: MF4000-12