ShopBot Buddy User manual
Page 2
Sbg 00217 Buddy Bumper Installation 2015 12 08 Copyright 2015 ShopBot Tools, Inc.
Revision History
Date:
ECO:
Change:
Author:
2015 12 08
New Release
M. Cummings
Page 3
Sbg 00217 Buddy Bumper Installation 2015 12 08 Copyright 2015 ShopBot Tools, Inc.
Table of Contents
Introduction .................................................................................................................................... 4
Installing the bumpers .................................................................................................................... 4
Page 4
Sbg 00217 Buddy Bumper Installation 2015 12 08 Copyright 2015 ShopBot Tools, Inc.
Introduction
The buddy bumpers create a physical barrier from the cutter. If a person is close to the Buddy Power
Stick, the bumper will nudge them to ensure proper clearance and safety.
NOTE: When bumpers are installed, the powerstick can only be removed from the front side.
Installing the bumpers
One of the bumpers has a notch cut into it. This bumper is the rear bumper.
Use ¼” allen wrench to install rear bumper (p/n 003301) onto rear side of powerstick with two screws
(p/n 002018).
Use ¼” allen wrench to install front bumper (p/n 003300) onto front of powerstick with two screws (p/n
002018).
Table of contents
