ShowMaven Tripod Series User manual

1
Tripod Series
Tripod Projection Screen
USER’S GUIDE
Tripod Screen Parts Identification
Tripod Screen Setup
A. Setting up the screen:
Follow the steps below and Fig. 1 & 2.
1. Place the screen in an upright position (fig.1) with the
legs toward the ground.
2. Deploy the Tripod Support legs by pushing down on
the Tripod Junction.
3. Turn the tripod’s screen casing in a 90-degree
horizontal position so that the screen casing is now
parallel to the ground with the screen handle facing the
bottom of the top hook.
4. Completely extend the legs as much as possible so
they are stable and position them away from objects that
may interfere with their balance. DO NOT stand the
tripod on an unstable platform to avoid an injury should
the tripod screen collapse.
Vertical locking sleeve ring
Vertical
Extension Bar
Screen Material
Screen case
Tripod junction
Tripod Support Legs
End cap
3
2
4
Fig. 2
Fig.1
1
Top hook & Screen
handle
Support beam
Carrying handle & Screen height
adjustment lock/release tab

2
1
2
3
4
B. Preparing the tripod screen for projection:
Follow the steps below and Fig. 3.
1. Pull the screen handle up vertically and hook the screen handle on the
groove of Top Hook.
2. Twist the Vertical Locking Sleeve Ring anti-clockwise to unlock the
current position of the Vertical Extension Bar and raise it as necessary to
the desired height.
3. Pull the Screen Height Adjustment Lock/Release tab out located just
above the Carrying Handle to raise or lower the bottom of the screen. Once
the desired height has been set, push the tab in to lock the position in place.
C. Disassembling the screen:
Follow the steps below and Fig. 4.
1. Unlock the Adjustment Handle by pulling the locking tab and slowly
slide the handle all the way down to bring down the position of the screen’s case.
2. Hold the Extension Bar and twist the Vertical Locking Sleeve Ring to unlock and release
the position of the extension bar. Once the extension bar has been brought all
the way down, unhook the screen material from the Top Hook and slowly
retract the screen back into the case.
*Note: It is very important to remember to hold the extension bar first and then
unlock the sleeve to prevent the extension bar from slamming and causing injury or
damaging the screen.
3. Turn the screen’s case vertically clockwise and insert the Top Hook’s
bottom pin to lock into the screen’s end cap hole.
4. Close the tripod legs by pushing them in. Lastly, tighten the Vertical
Locking Sleeve Ring by twisting it.
Note:
•To ensure the screen is stable, extend the tripod’s legs as much as possible.
•Do not fold the screen or allow any sharp objects to touch the screen’s surface.
•Use a soft-damp cloth to clean the screen surface; do not use chemical cleaning agents or
alcohol.
•Careful use will extend the lifetime of this product. Do not write or draw on the screen
surface.
•Don't use the projector screen in strong wind
Fig. 4
Fig. 3
2
1
3