Remaco FIX-1612V User manual

Step 1 Frame Assembly
Place the frame sections on the floor as
shown.
To form a rectangle, insert frame into the
metal angle joint bracket. Screw the
respective 2 holes with the screws provided.
Front View
Should the screen install in cold weather (Temperature below 18 degrees), please warm up the screen
by opening it and leave it with the room heater for an hour to allow fabric to expand.
This measure is to prevent the fabrics from tearing.
Warning
Back-view of the frame
Step 2
Default setting of the buttons are located at the outer
track. Outer track is ideal for room temperature above
25 Celsius.
Due to cold countries or low temperature room
(below 25 Celsius) may cause fabrics to contract
thus Inner track has to be used. In that case simply
shift snap button to the inner track as shown.
Place 1 moveable button and screw it in
place on the provided hole in one of the
desire track.
Back-view of the frame
Installation Guide (FIX SERIES)
CCOPYRIGHTS 1998 REMACO TECHNOLOGIES PTE LTD Website: www.remacotech.com
FIX
V: 9.0
Back-view of the frame
Inner track
Outer track
Snap Button

End
Step 3
Screen Fabrics Assembly
Lean the frame with buttons facing you.
Place screen fabrics on the frame with the
projection surface facing in front.
Fabric
Back View
1
2
4
3
snap button
Step 4 Step 5
Fix up the vertical support frame as shown.
Button the corner of fabric
onto the frame starting
from one corner indicated
as . Proceed with
diagonal corner follow
by and as shown in
the picture.
Button the fabric on the
frame starting from the
midd of each edges as
shown. Snap up for the
rest of the buttons.
Important Notes:
All screens are thoroughly inspected and fully tested operational in factory.
We accept no liability whatsoever for any losses due to improper installation, operation, or any unauthorized alternation at the point of installation.
All trademarks contained in this installation guide are the property of their respective owners.
Ceiling Positioning
The screen is provided with adjustable brackets which allow ease of installation.
Hook o
n
Front View
Step 7
Step 6
Fabric
Back View
Spacers (8 Nos.)
Cap Screw M6x55 (8 Nos.)
Vertical Support Frame
Bracket (4 Nos.)
Fabric
Back View
Spacers (12 Nos.)
Cap Screw M6x55 (12 Nos.) Vertical Support Frame
Bracket (6 Nos.)
(For FIX-6045V/C to FIX-7052V/C)(For FIX-4030V to FIX-5541V/C)
( Note: For FIX-1612V to FIX-3721H series, please proceed to Step 7)
1
2
34
Bracket
8.5cm
Back View
( Note: For FIX-2519V to FIX-3023V series )