Sierra Flame WM-FML-STL Series User manual

Fix your Fireplace
WM-FML-STL series
All manuals and user guides at all-guides.com
all-guides.com

Contents
•How to replace LED light
•How to replace flicker motor
•How to replace the heating element
•How to replace the PCB board
•How to replace the signal receiver
•How to replace the touch panel
All manuals and user guides at all-guides.com

Replace LED light
Step 1
Unplug the mood light located
on the left side behind the front panel
Unplug the mood light before you remove the front panel
Replace ember bed LED light
All manuals and user guides at all-guides.com

Step 2
Unscrew one screw on
each side behind the
front steel panel to remove
Surround.
All manuals and user guides at all-guides.com

Unscrew 4 screws where red arrows marked to remove two side panels
Step 3
ZOOMED
VIEW
All manuals and user guides at all-guides.com

Step 4
Unscrew 8 screws as circled in red to remove front bottom panel
NOTE: Please be careful when you remove the steel panel and mind the ember
bed glass panel.
All manuals and user guides at all-guides.com
all-guides.com

Move the front bottom panel outward slightly in order to access the glass ember bed panel.
Carefully remove the glass ember bed panel and set aside in a safe place.
All manuals and user guides at all-guides.com

Step 5
After the front bottom panel is removed, now you can
change the ember bed LED light. Unplug and replace it
with a new one.
All manuals and user guides at all-guides.com

Replace flame effect LED light
Unscrew the screws circled in red to remove 2 fending bars and the flame effect plastic
board.
Step 6
All manuals and user guides at all-guides.com

After the plastic board is removed, you can see the LED flame effect strip.
Unplug to remove and replace with a new one.
All manuals and user guides at all-guides.com

Replace flicker motor
Please follow Step 1 to 6 in replacing LED light.
The flicker motor is behind the flame effect plastic board.
All manuals and user guides at all-guides.com
all-guides.com

Step 1
Unscrew the screw and disconnect the flicker rod from the
flicker motor.
All manuals and user guides at all-guides.com

Unscrew 4 screws Now you can
replace the motor
Step 2
All manuals and user guides at all-guides.com

Replace the heating element
Please follow Step 1 to 6 in replacing LED light
Unscrew 2 screws on each side of the steel bar fixing
the LED light
In detail
Step 1
All manuals and user guides at all-guides.com

Unscrew 2 screws on front bottom and 2 on back bottom as pictures
show( red circled)
Step 2
Back
Front
All manuals and user guides at all-guides.com

Now you can remove the heating assembly
All manuals and user guides at all-guides.com
all-guides.com

Step 3
Unscrews 4 screws at the bottom of the
heating assembly and you can get out
the heater. Now you can change a new
heating element.
All manuals and user guides at all-guides.com

Replace PCB board
Please follow Step 1 and 5 in replacing LED light
Unscrew 3 screws on front bottom as circled in red. These 3 screws
are connecting the PCB board setting with the front bottom panel.
Step 1
All manuals and user guides at all-guides.com

Now you can get out the PCB board and replace it with a new one.
All manuals and user guides at all-guides.com

Replace signal receiver
Please follow Step 1 to 6 in replacing LED light
The receiver is fixed on the inner back wall of the fireplace
All manuals and user guides at all-guides.com