Ilumina USB - Rechargable LED Bicycle Headlight
Instruction Manual
Charging Batteries:
1. Lift the USB Port cover on the bottom of the Ilumina USB & attach the
Mini USB connector (smaller size connector) of the included
USB charging cable - See Figure 1
2. Connect the USB connector of the cable to either a computer USB port
or USB battery charger
3. Replace top cover & secure in place
Battery Status:
The Ilumina USB power button will light to indicate the battery status
while charging - See Figure 2
- Red - battery level is low & should be fully charged
- Green - battery is charging
- Off (no light) - the battery is fully charged
*Note - charging time is approximately 3 to 3.5 hours via USB port (from empty to full)
Figure 1
Install Handlebar Mount:
1. Select a location to mount the Ilumina USB on the handlebar that does not interfere with the safe operation of
the bicycle
2. Remove the bolt & wrap the mount around the handlebars with the release tab facing the rear of the bicycle
(use included rubber spacers if needed) - See Figure 3
3. Reinstall the bolt & tighten until the mount is securely attached to the handlebars - See Figure 4
Figure 3
Installation & Removal of Light:
1. Slide the Ilumina USB onto the mount from the front until it clicks
& is locked in place - See Figure 5
2. Adjust the beam to the proper angle
3. To remove the light, slide it forward while pressing the release tab
Figure 5
Operation:
1. Press the power button one time for steady (high) mode
2. Press the power button two times for steady (low) mode
3. Press the power button three times for flash mode
4. Press the power button four times to turn off
04-0892A
Serial Number
Figure 4
Limited One Year Warranty
This warranty covers the original purchaser & guarantees the product to be free of any defects in materials or workmanship for one (1) year from the
date of purchase of the product. SIIG will repair or replace (with an identical product or product having similar features & functionality) the product if
defective in materials or workmanship.
Please go to the Support section at www.siig.com & select the "Request RMA" link to submit an RMA request or fax a request to 510 657-5962.
SIIG, Inc. is located at 6078 Stewart Ave., Fremont, CA 94538-3152 USA. You do not have to complete any registration with SIIG to obtain warranty service.
The customer is responsible for shipping costs to SIIG Inc., but SIIG Inc will pay the return postage.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Figure 2
