Silvan Selecta Spotpak 50L User manual

Instruction Manual
MANSP50 REV F 01/04/16
Spotpak
50L
100L
200L
SILVAN AUSTRALIA PTY. LTD.
ABN 48 099 851 144
VICTORIA (HEAD OFFICE)
244- 264 Greens Rd,
Dandenong South, 3175 Australia
Telephone: [phone]
Facsimile: [phone]
www.silvan.com.au
NEW ZEALAND
22 Sunshine Avenue
Te Rapa, Hamilton, 2001 New Zealand
Telephone: [phone]
Fax: [phone]
www.silvannz.co.nz

SilvanWarranty
Our goods come with guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure and for compensation
for any other reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.
Wewarrantourgoodstobefreefromdefectsinmaterialsandworkmanshipforthewarrantyperiodof
12monthsfromthedatetheproductisdeliveredtotheconsumer.
SilvanwarrantsitsauthorisedDealer,whointurnwarrantstheoriginalpurchaser(consumer)ofeach
newSilvanproductthatitwillrepairorreplacetheproduct,or,paythecostofrepairorreplacement,
asdeterminedbySilvanwithoutchargeforlabouroranydefectiveormalfunctioningpartsin
accordancewiththewarrantylimitationsbelow.
ThisWarrantyisinadditiontoanyotherrightsandremediesavailabletoconsumersunderthelaw

This Warranty Covers
Onlyconditionsresultingdirectlyfromdefectsinworkmanshipormaterialundernormaluseand
service.

Warranty Exclusions
TheWarrantydoesnotcover:
• Conditionsresultingfrommisuse,useofincompatiblechemicals,exceedingmachine
specificationsincludingoverloading,impactdamage,negligence,accidentaldamageorfailure
toperformrecommendedmaintenanceservicesasspecifiedintheOwner/OperatorManual
applicabletotheproduct.
• Damagecausedbycontinueduseofaproductafterinitialfailure
• AnyproductwhichhasbeenrepairedbyotherthananauthorisedSilvanserviceoutletinaway
which,inthesoleandabsolutejudgmentofSilvan,adverselyaffectitsperformanceor
reliability.
• Thereplacementofmaintenanceitemssuchasdiaphragms,batteries,Vbeltsandground
engagingcomponents,etc.

How to claim Warranty
Returnthegoodstotheplaceofpurchaseatyourcostandwithinthewarrantyperiodalongwith
evidenceofthepurchasedate.IftheoriginalsuppliercannotbecontactedthencontactSilvanasbelow
andwecandirectyouonhowtoproceedwithyourwarrantyclaim.

How your claim will be managed
Therepairofadefectiveproductqualifyingunderthiswarrantywillbeperformedbyanyauthorised
Silvanserviceoutletwithinareasonabletimefollowingthedeliveryoftheproduct,atthecostofthe
owner,totheserviceoutlet’splaceofbusiness.Theproductwillberepairedorreplaceddependingon
theextentoftheproblematthediscretionofSilvanandtheSilvandealer.
New Product Warranty

Warnings !
You need to read carefully and take note of the following warnings before attempting to operate or install this sprayer.
Failure to comply with these warnings may result in serious injury or death.
Warning ! This sprayer is designed and manufactured solely for the purpose of applying agricultural chemicals to plants.
Under no circumstances may it be used for any other purposes.
Warning ! Prior to sprayer usage all users and operators must have read and fully understand the contents of this
operation manual
Warning ! Do not exceed the the vehicle manufacturer’s specified safe load and carrying capacity.
Warning ! Exercise extreme care when operating in hilly or uneven terrain to ensure proper stability. Refer also to the
vehicle manufacturer’s operating and safety instructions
Warning ! Refer to the chemical manufacturer’s label for correct use and safe handling instructions of chemicals before
use
Warning ! Never allow inadequately trained personnel to attach or operate the implement
Warning ! Before carrying out maintenance work, wash the sprayer thoroughly to remove all toxic chemicals that may
contaminate the sprayer.
Warning ! Do not point spray gun at any part of the human body.
Warning ! Do not pump flamable liquids or operate the pump in an explosive environment.
The following “Safety” decal should be fitted to the machine at all times in the location shown in the diagram. If the decal
is missing or unreadable it should be replaced by ordering a new decal from your Silvan dealer by the part number, DEC
90.
P/No DEC48
Safety Information

GENERAL
The Silvan Spotpak is a compact portable sprayer.
Whether you are a commercial grower, or a home gardener you will find many uses for this unit. The tank pump and
wand fittings are corrosion resistant and are suitable for applying weedicides, herbicides, insecticides, fungicides,
miticides, organic and green formulations.
It is designed for spot spraying but may be used in conjunction with a boom for boom spraying.
STANDARD SPECIFICATIONS
IMPORTANT INFORMATION ABOUT SPOT SPRAYERS
.
Silvan Spotpak’s feature a positive displacement diaphragm pump with a pressure sensing switch. The pressure switch
interrupts power to the pump when the system pressure builds towards maximum and power is resumed to the motor
when the pressure falls.
When the spray lance trigger is depressed fluid is released and the pressure will drop allowing the pressure switch to
resume power to the pumps motor.
Depending on your spraying requirements you may need to change or adjust the nozzle to suit your desired droplet size or
spray pressure.
Spotpak’s fitted with the Smoothflo model pump are designed not to pulsate and should stop pumping when the valve or
spray gun trigger is released. If the pump fails to stop pumping see the trouble shooting section.
TANK
50, 100 or 200 liter molded translucent U.V. stabilized
and impact resistant polyethylene. Screw on lid has
anti-spill breather.
PUMP
Smoothflo 12 volt DC electric, 7 L/min open
flow, Max 120psi on demand electric
pressure switch. Valves: Viton, Diaphragm:
Santoprene. The Smoothflo pump is designed
with adaptive pressure sensing technology that
prevents pressure spikes while maintaining
higher pressures and flows
CONTROLS
On/Off power switch.
The pump is fitted with an automatic electric pressure
sensing switch which automatically starts the pump
when the pressure falls and stops the pump when the
pressure reaches 120 psi
HOSE
6 metre delivery hose standard.
LANCE
Lightweight lance with adjustable nozzle.
FILTRATION
Suction line foot filter.
DIMENSIONS
50 LITRE 100 LITRE 200 LITRE
Length 700 mm 800 mm 1000 mm
Width 400 mm 475 mm 540 mm
Height 300 mm 395 mm 530 mm
Capacity 50 liters 100 liters 200 liters
Weight 6 kg 10 kg 14 kg
Specifications

Do not exceed the vehicle manufacturer’s specified safe load and carrying capacity.
SETTING UP YOUR SPOTPAK
The hose is supplied fitted at one end to the spray lance.
Fit the white elbow fitting to the outlet of the pump and finger tighten.
FITTING INSTRUCTIONS
Position the sprayer so as to minimise contamination to the operator. With the pump mounted away from operator the
risk of contamination due to hose failure can be minimised. It is recommended that the sprayer be securely attached to
any ATV or other vehicle. Refer to manufacturer’s instructions for appropriate load limits and fitting positions.
Note : 1 litre of water = 1 kg.
Never fill spray tank to a capacity beyond the specified overall weight limits set by your vehicle manufacturer. Recesses
in the top of the tank allow for tie down straps. When fitted these should be firmly secured to approved attachment
points on the ATV or other vehicle.
The sprayer should be mounted centrally and as near to the centre of gravity of the ATV as possible. It should not
protrude so as to cause an obstruction.
CONNECT GUN AND TRIGGER
For 50L spotpak sprayer, there is a gasket which
should fit between lance and trigger. The small
side is positioned face to trigger.
SPRAY LANCE HOLDER
Supplied with the Spotpak is a pair of clips for holding the
Spray lance to the tank for easy storage and transport. To fit
orientate the clip as shown and pres to the locating lug in the
tank. Below the Lug is a threaded brass insert embedded in
the tank; attach the provided screw to tank using a phillips
head screwdriver.
Installation

CONNECTING TO 12 VOLT DC SUPPLY
The Sprayer requires a 12 volt DC power source. A three metre loom is provided
with the sprayer to allow the sprayer to be connected to the 12 volt DC source
available. Connect the alligator clips remembering the brown or red wire is positive
and the blue or black is negative. The other end of the power loom features a plug
with keyway to ensure connection with correct polarity that connects to the pump. If
you extend the wire use wire of the same gauge or larger.
An on/off switch is fitted to the sprayer to allow the sprayer to be switched off from
the 12 volt DC source to prevent accidental drain of power. The switch also allows
the pump to be shut down when the tank is empty preventing overheating and damage
to the pump.
The wiring loom is installed with a 10 amp blade fuse to prevent any potential
damage to the electrical system of the vehicle.
SETUP AND TESTING.
It is always recommended that you first test all spray equipment thoroughly with clean water.
Silvan Spotpaks are supplied with a blue adjustable nozzle containing a large orifice which when twisting the tip can
allow for a greater flow of liquid. It is recommended that adjustable nozzle is used first and can be changed later if you
require.
1. Be sure to wear safety equipment as recommended by the chemical manufacturer before adding chemical to the
sprayer
2. Check the suction line foot filter is clean and undamaged (see Maintenance section).
3. Fill the tank with clean water.
4. With the 12 volt supply connected and the 6 meter spray hose and spray lance connected. Fit the blue adjustable
nozzle or any large orifice nozzle you may wish to use.
5. Check all pipes, hoses, hose clamps and connections for leaks or damage.
6. Switch the pump ON.
7. Depress the spray lance trigger. The pump is self priming and will start spraying within 30 seconds.
8. Check the hose connections for leaks, if any are found stop the pump and rectify the problem before continuing.
9. Slowly twist the tip of the nozzle from a course droplet size to a fine droplet to your preference. You can check the
spray pattern by spray pattern by spraying water on to a dry concrete floor.
.
Maintenance
Dispose of unused chemical and water used for rinsing in a manner that will not endanger people animals or
the environment.
After spraying rinse out the spray lines and tank with clean water
The foot filter should be checked and cleaned if necessary each time the tank is filled. To check the filter hook it out with
a bent piece of wire. Appropriate protective equipment including gloves should be used whenever maintenance is carried
out.
If heavy frosts are experienced, run the pump to make sure pump and spray lines are dry. This will prevent water
freezing in the pump or spray lines and damaging sprayer.

TROUBLE SHOOTING GUIDE
S
y
m
p
tom Remed
y
Pump does not operate
• Ensurebatterywiresareconnectedtobatteryproperly.
• ChecktheinlineFuseinthepowerloom
• Checkbatteryisnotflatorlow
• CheckterminalsarefittedtoOn/Offpowerswitch
• Checkthat2wiresareconnectedtopumppressureswitch
The pump continues to run when
the spray gun is off
• Checkifthereisaslowleakofliquid.Checkallhoseconnectionsand
thespraygunforanyleaks.
• Checkthetankisnotemptyorthesuctionfilterisnotfullyimmersed.
• Thepressureswitchmayneedadjusting,thepumpwillneedtobe
removedandgenerally1turnanticlockwisewitha1/16”allenkeywill
correcttheproblem
Pump operates with no flow or
reduced flow
• Thepumpwillonlyprimeiftheguntriggerison.
• Checkthefilterintankornozzleisnotblockedorthesprayhose
kinked.
• Pumpvalvesmaybestuckorblocked.Applyasmallamountof
pressuretothesuctionlinebyremovingthefilterandplacinga
gardenhoseoverthesuctionhoseinsidethetankwhilethepumpis
running.
Pump it getting very hot in
operation
• Voltagedrop/restrictioncausingexcessiveheat.Checkthatvoltageat
pumpis12Vwhenoperating.Removeextendedpowerloomif
requiredoruseheaviergaugewire.
• Pumpingatmaximumpressurewillusemoreampsandgenerate
moreheat.Checknozzleforrestriction
• Whenambienttemperatureisover21°Callpumpsoperatingat
higherpressureswillhaveadditionaltroubletokeepcool.Ifspraying
onhotdayconsiderusingforshorterperiodsoftimeorpumpingat
lowerpressure.
Spray Gun is leaking at lance or
nozzle • Checkiffittingisloose
• Washer/gasketbelongebetweenfittings;Checkthatparthas
notbeenlost.
Notes

SILVAN AUSTRALIA PTY. LTD.
ABN 48 099 851 144
244 – 264 Greens Rd
Dandenong South 3175
Australia
Telephone: [phone]
Facsimile: [phone]
www.silvan.com.au
SILVAN NEW ZEALAND PTY.LTD.
22 Sunshine Avenue
Te Rapa, Hamilton, 2001
New Zealand
Telephone: [phone]
Fax: [phone]
www.silvannz.co.nz