- 4 -
4. When you have finished shaving, slide the
On/Off switch 5downwards.
5. Clean the appliance as described in the chapter
"Cleaning and Care".
Trimming
The long-hair trimmer wintegrated onto the Men‘s Sha-
ver is suitable for trimming sideboards and moustaches.
1. Slide the switch for the long-hair trimmer e
upwards. The long-hair trimmer wraises itself.
2. Press the locking switch 4and, at the same
time, slide the On/Off switch 5upwards.
The long-hair trimmer wis running.
You can now trim the hairs as required.
3. When you have finished trimming, slide the
On/Off switch 5downwards.
4. Remove any loose hairs on the long-hair trimmer w
with the brush 9.
5. Slide the switch for the long-hair trimmer e
downwards. The long-hair trimmer wlowers
itself.
Changing the cutters
Risk of electric shock!
Before changing the cutters 2ALWAYS disconnect
the mains power plug! Otherwise, there is the great
risk of receiving an electric shock!
If...
- ... the shave is noticeably unsatisfactory,...
- ... you must run the Men‘s Shaver over the same spot
several times to obtain an acceptable result,...
- ... shaving takes noticeably longer,...
- ... damage is visible on the cutters 2,...
... the cutters 2must be exchanged.
New cutters can be obtained with the enclosed
order form.
When you have acquired a new set of cutters 2,
remove the old set of cutters 2:
1. Press the release button 3. The cutting unit 2
springs up.
2. Extend the cutting unit 2a little, so that it allows
itself to be pulled upwards.
3. Replace the new cutting unit 2back onto the
Men‘s Shaver. Ensure that it engages and sits
firmly.
Cleaning and care
Risk of electric shock!
Always remove the mains power plug before cleaning
the appliance! Otherwise, there is the great risk of re-
ceiving an electric shock!
Attention!
Do not use abrasive, chemical or caustic cleaning
agents to clean this appliance. They could irreparably
damage the appliance.
Cleaning with the brush
Clean the cutting heads 1with the brush 9after
every shave.
1. Press the release button 3, so that the cutting
unit 2springs up.
2. Carefully tap the cutting unit 2on a smooth
surface or blow the hair trimmings away.
3. Use the brush to remove the remaining hair
trimmings.
Cleaning under running water
The cutting unit 2is suitable for cleaning un-
der running water.
1. Press the release button 3, so that the cutting
unit 2springs up.
2. Hold the cutting unit 2under the flow of water
so that the water runs from the inside to the outside,
through the cutting heads 1.
