
GB│IE│NI│CY │ 7 ■SHMS 300 D2
5) Replace the mixing bowl 8on the mixer
stand 7.
6) Press the mixer holder release 6and
swing the mixer holder 7 back downwards.
7) Place the hand element qon the mixer
holder 7so that it firmly clicks into place.
8) Push the lid 0into the rails on the mixer stand 7
so that it sits firmly in place.
NOTE
► If you want to add ingredients during mixing,
open the filling opening 9on the lid 0and
add the ingredients. Close the filling opening
9afterwards to prevent ingredients from
spraying out!
You can use the hand mixer without the mixer
stand 7. We recommend using the hand mixer
without the mixer stand 7especially for small
amounts of liquid. Otherwise, the mixer cannot
reach all the liquid and it may not be properly mixed.
WARNING! RISK OF INJURY!
► Never use containers made from glass or
other easily breakable materials. These con-
tainers may be damaged and cause injuries.
9) Insert the plug into a mains power socket.
10) To start up the appliance, move the speed
switch 1to the desired speed setting. You can
choose between 5 speed settings and also
use the Turbo button/ 2(see section "Speed
levels").
NOTE
► If ingredients stick to the edge of the mixing
bowl 8and cannot be reached by the
kneading hooks t/whisks r, switch off the
hand mixer.
Remove the lid 0. Use the dough scraper zto
push the stuck ingredients back into the middle
of the mixing bowl 8. Replace the lid 0.
Switch the hand mixer back on.
11) To remove the contents of the bowl, switch off
the hand mixer. Pull the lid 0off to the side.
NOTE
► For safety reasons, the whisks rand knead-
ing hooks tcan only be released if the
speed switch 1is set to the position "0".
12) Press the mixer holder release 6, flip up
the mixer holder 7 and remove the mixing bowl
8from the mixer stand 7. You can now re-
move the contents of the bowl.
NOTE
► If you want to remove the whisks ror knead-
ing hooks t, you must first remove the hand
element q: To do this, press the hand mixer re-
lease 5and remove the hand element q.
Then press the tool-release button wto release
the whisks ror the kneading hooks t.
► For safety reasons, the whisks rand knead-
ing hooks tcan only be released if the
speed switch 1is set to the position "0".
IB_386388_SHMS300D2_LB6-.indb 7 22.06.2021 14:44:56