
PROYECTOR
FLOOD LIGHT
FLS50xWD, FLS100xWD,
FLS150xWD, FLS200xWD,
FLS300xWD
Montaje Installation
1.
-Opción de colgado (modo estándar) Hanging option (standard mode)
Manual de instalación
Installation guide
AVISO WARNING
•Por favor, lea el manual de instrucciones antes de
instalar el producto.
•El sistema debe ser instalado, conectado y probado
por un electricista certificado, basado en los
estándares de seguridad y las regulaciones locales.
•No sobrepasar la potencia nominal.
•El reemplazo solo puede ser realizado cuando la
lámpara esté apagada y se haya enfriado por
completo.
•Está prohibido cubrir el dispositivo con una tela o
material similar.
•Cualquier incumplimiento de estas instrucciones o
modificaciones en el dispositivo anulan la garantía.
•Su grado de protección IP65 asegura una completa
proteccióncontra el polvo y los chorros de agua.
•Please read the instruction manual before installing
the product.
•The lighting system should be installed, connected
and tested by certified electrician based in safety
standards and local regulations.
•Do not use over rated power lamp.
•Replacement only can be done when the power is off
and the lamp is complete cooled down.
•Insulation cloth or similar material is prohibited to
cover the lighting fixture.
•Any missuse of these instructions or any changes to
the fixture shall nullify the guarantee.
•Its protection rating IP65 ensures a complete
protection against dust and jets of water.
!
Enero 2022
January 2022
2.
3.
2. Conectar la fuente
alimentación a la línea eléctrica
2.Connect the power supply
to the power electrical line
3. Ajuste el ángulo vertical del
proyector
3.Adjust the vertical angle of
the floodlight
Este producto contiene una fuente luminsosa de la clase de efi ciencia energética D
This product contains a light source of energy efficiency class D
1. Insterar los tornillos en los
orificios indicados en el dibujo
1.Inster the screws in the holes
indicated n the drawing