Sinbo SS 4051 User manual

SS 4051 LADY SHAVER
INSTRUCTION MANUAL
EN
RU

- 1 -
ENGLISH
SINBO SS 4051
LADY SHAVER
INSTRUCTION MANUAL
Read these instructions for use carefully before using the appliance and save them for
future reference.
FEATURES
On/off switch
Trimmer and shaver
Stainless Steel Blade
Washable Design
Guide comb-1mm
Cleaning brush
Indicator light
Battery operated
2xAAA Battery (not included)
IMPORTANT SAFEGUARDS
1. Switch off when not in use and before cleaning or changing accessories
2. Keep appliance out of reach of children, close supervision is necessary if the appliance
is used near children. This appliance is not designed for use by persons with reduced
physical .sensory or mental capabilities, and should not be used by such persons unless
they can do so safely .where necessary, such person (or anyone with lack of experience
or knowledge) should first be given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
3. Keep appliance dry and away from areas where it is likely to get splashed. Never
immerse in water
4. Keep appliance away from heat, sharp objects or anything that may cause damage.
Ensure all ventilation slots; grilles etc. are kept clear of debris and foreign objects
5. Use this appliance only for its intended use as described in this manual.
Do not use attachments not recommended by the manufacturer.
6. When travel, should ensure that put the cover on the head, in order to protect the
shaving Foil head and long hair trimmer.
7. Do not operate the appliance if damaged or after it malfunctions.
8. Always ensure hands are dry before operating the product.
9. The unit contains a sharp blade. Take care to avoid contact between the blade and
skin, during use the maintenance
10. Do not immerse or use if dropped in water or any liquid

- 2 -
How to Charge
Battery Replacement
This appliance is designed for use with 2xAAA battery (1.5V) (not include). If the trimmer
motor shows down in operation or becomes less efficient, replace the battery. To replace
the battery, open off the bottom cover as shown in the picture below, insert AAA battery,
observing correct polarity, and re-fit bottom cover.
Dispose of used battens appropriately use local collection and re-cycling facilities where
available
To replace the battery
To insert the battery
NOTE:
Batteries must be inserted with correct polarity. Exhausted batteries should be removed
immediately and disposed of in accordance with the maker's recommendation.
Remove the batteries when the appliance is not in use for an extended period of time.
Do not short-circuit the terminals of the batteries or contacts inside the compartment
SHAVING
1. Remove the protective cover from the shaver head
2. Turn the slide switch to ON position 0
3. Hold the shaver head gently against the skin, and then move the lady shaver gently
against the direction of the hair
4. Move the shaver up and down or from she left to right, depending
on which movement you find most pleasant
5. TRIMMING: Push up the switch
6. Use long-hair trimmer for long hair, then use the shaving foil for
closer shave
7. Switch the device off after use and clear the head with the brush.
Clean and Care
1. To maintain your everywhere Trimmer carefully clean the cutting head each time after
use.

- 3 -
2. Remove cutting head by pulling the head away using the lateral indentation.(see
illustration)
3. Use the enclosed cleaning brush to remove all hairs that have collected in the cutting
head. Rinse cutting head off under running tap water, if necessary.
4. Put the cutting head back onto the everywhere trimmer so that it clips in audibly
5. Clean the body with a soft dry cloth
6. Clear the lady shaver every time you have used it
7. Do not use any corrosive detergents, scouring pads or cloths, petrol, acetone etc, to
clean the appliance.
8. Do not exert any pressure on the shaving foil to avoid damage.
DISPOSAL
When disposing of unserviceable appliance take all measures to prevent damage to the
environment. In particular, it is not recommended to burn the packing and of the unit,
as the dyes used in the manufacture and packaging of the device, the burning emits
harmful substances that can harm the environment and human and animal health.
In particular, it is not recommended to burn the packing and of the unit, as the dyes used
in the manufacture and packaging of the device, the burning emits harmful substances
that can harm the environment and human and animal health.

- 7 -

- 8 -
01-2019