SIRETTA LC300 Series User manual

LC300 Series
linkCONNECT Starter Kit
Quick Start Guide
Rev 1.2

inspired wireless technology
Whats in the Box?
As standard, the LC300 starter kit comes with the following*:
»LC300-XXXX modem
»Power supply
»Mike 1A antenna
»RS232 to USB cable
»Quick start guide
NOTE - The LC300 modem requires a SIM card to work. If you do not have a SIM card,
these can be purchased through Siretta. For more information please contact your Siretta
representative or call us on [phone].
*If you have purchased the LC300 as a standalone modem, you will need to purchase the other
accessories seperately from www.siretta.co.uk

inspired wireless technology
Setting up the LC300
Step 1. Insert a SIM card fully into the SIM slot. Once the SIM card has been correctly
inserted, a click will be heard.
SIM
Step 2. Screw the antenna onto the LC300. Twist the antenna connector clock-wise
until the antenna is rmly connected.*
*The antenna used in this drawing is different to the one supplied, however the application
process of the antenna is the same.

inspired wireless technology
Step 3. Using the supplied RS232 cable, connect the RS232 connector into the
RS232 port on the LC300. Connect the USB connector (other end of the cable) into a
USB port on your PC.
Step 4. Download the conguration tool using the following link.*
http://www.siretta.co.uk/downloads/cong_utility.exe
RS232 cable
*For more information please see the linkCONNECT Software Manual

inspired wireless technology
Step 5. Plug the power supply into the LC300. Ensure the mains supply is plugged
into a power source and switched on. The red LED on the LC300 will start ashing*,
this indicates that power has been supplied. See table 1 for LC300-GPRS LED
indication and table 2 for LC300-UMTS LED indication.
Flashing red LED indicates power on
LED colour State
Red (STAT_LED)
Flash rate once per second: Network search / not registered /
turning off
Slow rate once every 3 seconds: Registered full service
Constant ON: Ringing OR call in progress
OFF: Module power down
Green (GPIO 1) Reserved / Special Function / Test
Blue (GPIO 2) Reserved / Special Function / Test
Table 1. LC300-GPRS LED indication
*If this step fails, please try again. If it fails a second time, please contact your Siretta
representative or call us on [phone].

inspired wireless technology
Step 6. Select the correct COM port for your system and click ‘Connect’ in the
conguration tool window.
Change the device settings as required and click ‘Save’ to make changes to the unit.
LED colour State
Red (STAT_LED)
Constant ON: Network search / not registered / call in progress
Slow rate once every 3 seconds: Registered full service
OFF: Module power down
Green (GPIO 1) Reserved / Special Function / Test
Blue (GPIO 2) Reserved / Special Function / Test
Table 2. LC300-UMTS LED indication
Your LC300 is now ready to connect to your application using the system settings.
NOTE - For more information please see the ‘linkCONNECT Software Manual’

inspired wireless technology
Further Information
For more information when using your LC300, a range of hardware and user manuals
are available to download. You can request these from your Siretta representative,
alternatively these can be download from www.siretta.co.uk

Basingstoke Road
Spencers Wood
Reading
Berkshire
RG7 1PW
United Kingdom
Rev 1.2
sales
fax
accounts
email
Company No. 08405712
VAT Registration No. GB163 04 0349
A member of the Olancha Group Ltd
[phone]
[phone]
[phone]
[email protected]
www.siretta.co.uk