SISTEMA TWIST 'N' SIP Configuration guide

TWIST ‘N’ SIP™Cleaning Instructions
Please visit the Sistema website for more information and cleaning videos.
www.sistemaplastics.com
330ml, 460ml and 620ml TWIST ‘N’ SIP™Bottle - VERSION 2
3.1 3.2
OR
3.1 Wash all bottle and
lid components in the
dishwasher (top rack only).
or...
3.2 Hand wash all bottle and
lid components with hot soapy
water. Clean the bottle base
with a bottle cleaning brush.
1. With nozzle open locate groove on lid base, and using this
groove place fingernails under the lid cover. Pull to remove
lid cover and nozzle from lid base/bottle.
NB; If having difficulty removing lid cover try soaking the
lid in warm water for a few minutes first.
1.0
5. While holding down the nozzle (ensuring the nozzle and
lid cover are held together tightly), TWIST the lid cover onto
the lid base clockwise. Press down to click the lid cover into
place. Check cap function by twisting the cap cover anti-
clockwise to open the nozzle. Enjoy!
5.0
4. Ensure all components of bottle and lid are completely
dry before reassembling. When reinserting nozzle into lid
cover ensure rail and guide markers line up as shown.
4.0
2.1 The bottle nozzle is held in place by two clips; push in
the sides of the inner lid cover while pulling the nozzle to
remove from the lid cover. 2.2 Unscrew the lid base and
remove from bottle.
2.1
2.2
VERSION 1 OR VERSION 2? To tell the difference between
the bottles, version 2 has ‘V2’ or a slot/groove engraved on
the base of the bottle and a thumb groove on the lid.
V2
slot/groove
thumb groove

TWIST ‘N’ SIP™Cleaning Instructions
Please visit the Sistema website for more information and cleaning videos.
www.sistemaplastics.com
330ml, 460ml and 620ml TWIST ‘N’ SIP™Bottle - VERSION 1
1. Place cap in boiling water for 30 seconds and remove cap
safely after time is up. Put cap back on bottle.
2. Whilst still hot, twist cap so that nozzel is open. Using
thumbs, apply pressure between lid cover and lid base to
release lid cover.
3. Wash the components in the dishwasher (top rack only),
or hand wash in hot soapy water. Clean the bottle base with
a bottle cleaning brush.
4. To reassemble, place lid cover onto lid base and align
indicator tabs.
5. While holding down the nozzle, twist the lid base onto
the lid cover. Then firmly press the lid cover and lid base
together until it snaps shut.
6. Place cap back on bottle and check cap function. Enjoy!
Caution: Be careful when using boiling water.
1.0 2.1
2.3
2.2
2.4
3.0 4.1 4.2
5.1 5.2 6.0