Sizewise Bari Lift and Transfer User manual

Bari Lift and Transfer™
Quick Reference Guide
This card is not meant to replace
product user manual. For complete
manual, contact Sizewise.
800-814-9389
sizewise.com

Components
Battery
To power lift ON/OFF:
Turn battery on by turning
red button clockwise. To
turn o, press red button
Note: Lift will not operate
when plugged into wall
outlet.
To charge battery: Plug lift into a hospital-grade
outlet with supplied cord.
Spreader Bar
Sling
Lift Base
Front Casters
Weight Adjusment
Lift Arm
Hand Control
Battery
Foot Plate
Rear Casters

Hand Control
Expanding base adds stability when patient is in lift.
Weight Adjustment
Sling Positioning/Attachment
Weight capacity can
be adjusted to 750 lbs.
or 1,000 lbs. Loosen
black knob and move
slider clamp to desired
weight capacity. Tighten
knob when slider clamp
is in place.
1. Center sling under patient. Top border should
be even with patient’s shoulders. Follow facility
SPHM guidelines.
2. Position spreader bar perpendicular to patient’s
sternum. Attach color-coded straps onto
spreader bar.
3. Upon lifting, ensure patient is not pitching
forward. If so, repeat process with Step 1.
Lowers
Lift Arm
Retracts
Lift Base
Raises
Lift Arm
Expands
Lift Base

sizewise.com 800-814-9389
OPS-0005-1218 27650009, Rev. 3.0
Emergency Release
Slide red clip up for
emergency release.
Note: Emergency release
allows arm to be lowered
in case of patient
emergency or battery
power interruption.
Warning: Do not stand beneath Lift Arm, Spreader
Bar, or patient when using emergency release.
Digital Scale Operation
1. While sling is empty, press ZERO button to set
system to zero. The digit 0 will pan across display
for a few seconds, then display will read 0.0
Note: Always re-zero scale before weighing patient
2. Remove sling from spreader. Position patient in
sling, then reattach sling to spreader bar.
3. Carefully lift patient. When motion has stabilized,
press WEIGH to display patient weight.
Note: Display will automatically turn itself o after
60 seconds. If display turns o before you are able to
view weight data, press WEIGH again.