SleepSafe Beds Dreama RETROFIT KIT User manual

3629 Reed Creek Dr. / Bassett,VA 24055
Toll Free: 866.852.2337
SleepSafeBed.com
[email protected]om
RETROFIT KIT
LOWER SAFETY RAILS.
REMOVE MATTRESS.
LOOSEN 3 SCREWS, REMOVE 1
INTHE 2ND BED DECK PANEL.
With 4mm Allen Wrench (or drill with bit),
loosen 3 screws and remove 1 in the deck
panel as shown.The purpose is to allow
room to feed the strap beneath the deck.
How to install a Dreama
TM
System into a SleepSafe® Bed
Includes: Dreama
TM
24hr Positioning System; Deck Pad; Deck Strap; Deck Screws
Tools Needed: 4mm Allen Wrench (Included) or Drill with 4mm Allen Bit
FEEDTHE STRAP BENEATH
BOTH SIDES OFTHE DECK PANEL.
Feed the strap beneath the deck. The buckle
should line up with the loosened screw.
Once buckle in place, replace removed screw,
and then tighten all the screws.
BUCKLE
POSITION ON DECK
PLACE PAD
ON TO THE DECK.
BUCK LE
POSITION ON
PAD

PLACE PAD
ON TOP OF
THE DECK.
HEADBOARD
Loosen
Screw
LOOSENED
SCREW
Remove Screw
Loosen Screw


STRAP IS FED BENEATH THIS DECK PANEL
EXCESS STRAP
USED TO SECURE
DREAMA TO BED
PLACE PAD ON TOP OF DECK
INSIDETHE SLEEPSAFE BED.
EXCESS STRAP
Note the position
of the strap
buckle once the
pad is placed on
top of the deck.
Loosen
Screw

THREAD STRAPTHROUGH BASE OF DREAMATM SYSTEM. THENTIGHTEN STRAP.
Thread the strap through the holes in the 8th row on each side of the DreamaTM System base.
Once in place and the buckle is securely tightened, the DreamaTM System bolsters can be installed.
UNROLLTHE DREAMA SYSTEM
ONTO THE PAD AND FIT INTO BED.
The DreamaTM System base is rolled up and
needs to be unrolled and placed on the pad
inside the bed. Also, locate the holes in the base
where the strap will be threaded. See below.
*INSTALLATION NOTES: For beds with xed foundations, use the same process but wrap the strap around the bunkie board or box spring.
BUCKLED
POSITION
ON PAD.


Strap will be threaded through these holes
on each side of the DreamaTM System base.

8TH ROW 8TH ROW
HEADBOARD
DreamaTM System base
ATTACH ALL BOLSTERS TO BASE. THE TWOWIDER BOLSTERS GO ON EACH END.
Each bolster attaches by inserting their plastic tabs into the DreamaTM System base. Be sure to attach each side.
Start at the head with a wider bolster, continue with narrow bolsters, and nish with the other wider bolster.
ATTACHTHEWIDER
BOLSTER FIRST. FINISHED
BOLSTER
INSTALLATION
ATTACH BOLSTER
TO DREAMA BASE. CONTINUE
ATTACHING
ALL BOLSTERS.
WI 820.120-13 Rev. 01 | [Dreama Retrot Kit] | Issue Date: 10/26/2020 | Page 1 of 1