SLEIPNER MOTOR AS SIDE-POWER 86-08955 User manual

Made in Norway
©Sleipner Motor AS 2014
SLEIPNER MOTOR AS
P.O. Box 519
N-1612 Fredrikstad
Norway
Tel: [phone]
Fax: [phone]
www.side-power.com
[e-mail]
Keep this
manual onboard !
86-08955
Windlass Control Panel
v1.0
SIDE-POWER
Windlass Systems
Installation manual
EN
Installasjon manual
NO

Control Panel 86-08955 version 1.0 - 2014
2
Content/Innhold
Product Features/Produkt oversikt..................................................................... 3
Installation ............................................................................................................ 4
Installasjon ........................................................................................................... 5
Wiring diagram/Koblingsskjema ....................................................................6-7
Important !
These panels will only work with Sidepower electric windlass with a built in electronic
control box and a 4/5 lead control cable system. These panels are waterproof from the
front end when correctly installed. However, you must ensure that they can never be
submerged in water as this might cause a shortcircuit and thereby causing the thruster to
start unintededly.
Viktig !
Disse kontroll panel fungerer bare med Sidepower elektriske vinsjer med integrert
elektronisk kontroll boks og 4/5 leders kontroll kabel system. Disse panelene er vantette
fra fronten når de er korrekt installert. Men, de må aldri stå slik att de er under vann da
dette kan gi en kortslutning som kan føre til selvstarting av trusteren.
DECLARATION OF CONFORMITY
We, Sleipner Motor AS
P.O. Box 519
N-1612 Fredrikstad, Norway
declare that this product with accompanying standard remote
control systems complies with the essential health and safety
requirements according to the Directive 89/336/EEC of 23
May 1989 amended by 92/31/EEC and
93/68/EEC.

Control Panel 86-08955 version 1.0 - 2014 3
Product features/Produkt oversikt
Ref: Pcs. Parts:
1 1 x Control panel - Kontrollpanel
2 1 x Gasket - Pakning
3 4 x Screws (A4) - Skruer
4 4 x Front ring - Frontring
1 234
UPDOWN ON 2 OFF

Control Panel 86-08955 version 1.0 - 2014
4
Installation
Installation:
Find a comfortable position for the panel where it does not obstruct or are
obstructed by other controls. Use the enclosed cut-out pattern to mark the
area. Cut out the circular area as shown on pattern.
If the front surface around your cut out is jaggered or chipped, use a sealant
to assist the gasket.
APut the gasket (2) in its designated track in the back face of the panel (1).
BConnect the contact with the control cable from the windlass .
CConnect the control output to the Sidepower automatic main switch if
installed.
DPut the panel (1) in place and screw in and tighten the four screws (3).
EGently twist on the decor-/front ring (4) clockwise.
NB ! If the windlass runs the opposite way of the panel, swap positions of
the grey and the blue control cables in one contact, by the control box unit.
EN

Control Panel 86-08955 version 1.0 - 2014 5
Installasjon
Installasjon:
Finn en god posisjon for panelet hvor det er lett tilgjengelig og ikke blokker-
er andre kontroll enheter. Bruk den medsendte malen til å merke av områ-
det, og skjær ut det merkede området. Dersom kantene rundt utskjæringen
blir skadet/ujevne på fremsiden må det benyttes en tetningsmasse sammen
med pakningen for å sikre god tetning.
ASett inn pakingen (2) i sporet på baksiden av panelet (1).
BKoble kontakten sammen med kontroll kabelen fra vinsjen.
CKoble kontroll signalet til Sidepower automatisk hovedstrømsbryter der-
som installert.
D Sett panelet (1) inn og skru inn de re skruene (3).
EVri på den medleverte frontringen (4) medurs.
NB ! Dersom vinsjen skulle gå motsatt vei av panelet, bytt plassering på den
grå og den blå kontroll ledning i en kontakt, ved kontrollboksen.
NO

Control Panel 86-08955 version 1.0 - 2014
6
Wiring diagram/Koblingsskjema




  























  








  









Control Panel 86-08955 version 1.0 - 2014 7
Wiring diagram/Koblingsskjema




  



















  



















Worldwide sales and service
www.side-power.com
SLEIPNER MOTOR AS P.O. Box 519 N-1612 Fredrikstad Norway
Tel: [phone] Fax:[phone] www.side-power.com [e-mail]