SMARDY Blue H2 User manual

0®
Wasserstoffwa
sser
Generator
Hydrogen Generator
H2
Manual

Step2
✔At first commissioning, the SPE memebrane
must be activated. Fill the generator with
approx. 90°C hot water.
✔Start (without the upper bottle closure –
otherwise the gas cylinder could explode due
to the resulting pressure) the device.
✔Repeat this process 10 times (use freshly
boiled water with every process). Then the SPE
membrane is fully activated.
QUICK START GUIDE
Step1
✔Fill the hydrogen generator with a little cold
water and connect to the power supply, fully
charge until the green LED light illuminates
✔Pay attention to a tight screw connection
and if necessary check
or replace the seals in case of
water leakage.
Step3
✔Repeat this process 10 times. Then the SPE
membrane is fully activated.
✔Fill the hydrogen generator with a little cold
water and reconnect to the power supply,
charge until the green LED light illuminates
✔Completely fill the generator with cold
(osmosis, still mineral or nitrate-free tap water)
water. Start the device and enjoy H2
hydrogen-rich water.
ATTENTION: only use still Water!
There should be no carbon dioxide in the water.
** Drink daily up to 0,3 l per 10 kg body weight.

Chapter Overview
•01 –General safety instructions
•02 –Scope of supply
•03 –Charge mode
•04 –Operation
•05 –Internal cleaning
•06 –External cleaning
•07 –Hydrogen water–Not only drinking
•08 –Troubleshooting
•09 –Legal and imprint

✓Only operate the device when you have read and understood
the instruction manual.
✓Before you switch on the device, the water container must be
filled with water. Otherwise the electrolyc cell could be damaged
and this will invalidate the guarantee.
✓You may not fill water of over 90°C.
✓Only use the device with 220 Volt.
✓Ensure that children and pets do not have access to the device.
✓Never submerge the device in water. A damp cloth is sufficient for
cleaning. Do not use chemical cleaning agents.
✓Never drop the device.
✓Preferably use cold water (under 30°C)
✓Do not expose the device to direct solar irradiation or
temperatures under 0 or over 50 degrees.
✓If during the production water leaks out of the device, stop the
operation.
✓Do not place the device in damp or polluted areas.
✓Do not use the power supply, if it is damaged or when the
cable was kinked.
✓Do not place heavy or sharp objects on top of the
power cord.
✓Do not touch any parts that are connected to the mains
power supply with damp fingers.
✓Only use water of best drinking water quality (osmosis, hot
or still mineral water), if you subsequently want to drink
the water.
✓You may not use carbonated water (sparkling water, sparkling
mineral water). In doing so, the device could explode.
✓Do not open either the power supply unit or the base unit and
do not attempt to repair in case of a defect. In the event of a
defect, immediately disconnect the device from the mains
and inform your dealer.
1 - General safety instructions

2 –Scope of supply