SMART-AVI DVN-16Pro User manual

DVN‐16Pro
Quick Start Guide
800.AVI.2131
Tel: [phone] |Fax: [phone]
11651 Vanowen St. North Hollywood, CA 91605
SmartAVI.com
Designed and Manufactured in the USA
WHAT’S IN THE BOX
NOTICE
The information contained in this
document is subject to change without
notice. SmartAVI makes no warranty of any
kind with regard to this material, including
but not limited to, implied warranties of
merchantability and fitness for particular
purpose.
SmartAVI will not be liable for errors
contained herein or for incidental or
consequential damages in connection with
the furnishing, performance or use of this
material.
No part of this document may be
photocopied, reproduced, or translated
into another language without prior written
consent from SmartAVI Technologies, Inc.
20160825 Access and Control 16 Computers
with One USB keyboard, USB
Mouse and DVI-D Monitor
16-Port DVI-D KVM Switch
with Audio and USB 2.0
Sharing
PART NO. QTY DESCRIPTION
DVN-16PROS 1 DVN-16Pro, 16x1 DVI-D, USB
2.0, Audio Switch
PS5VDC4A 1 Power Supply/Adapter
1 Quick Start Guide
EN-DVN16P-
EAR-P 2 Mounting Brackets
TECHNICAL SPECIFICATIONS
VIDEO
Format DVI-D Single Link
Maximum Pixel Clock 165 MHz
Input Interface (16) DVI-D 29-pin (female)
Output Interface (1) DVI-D 29-pin (female)
Resolution Up to 1920 x 1200 @60Hz
DDC 5 volts p-p (TTL)
Input Equalization Automatic
Input Cable Length Up to 20 ft.
Output Cable Length Up to 20 ft.
AUDIO
Input Interface (16) 3.5 mm Stereo Audio
Output Interface (1) 3.5 mm Stereo Audio
Impedance 600 Ohm
Frequency Response 20 Hz to 20 kHz
USB
Signal Type USB 2.0, 1.1, and 1.0 w/ inter-
nal hub
Input Interface (16) USB Type B (female)
Output Interface
(2) USB Type A (female) for
keyboard and mouse emula-
tion;
(2) for USB 2.0 Transparent
CONTROL
Front Panel Buttons and LCD Display
RS-232 Via Control @ 115200 bps
Hotkeys Via Keyboard
OTHER
Power External 100-240 VAC/
5VDC4A @20W
Dimensions 17” W x 3.625” H x 7.5“ D
Weight 5.3 lbs.
Common Mode Rejection at 60 dB
Nominal Level 0-1.0 V
Operating Temp. 32-131 °F (0-55 °C)
Storage Temp. -4-185 °F (-20-85 °C)
Humidity Up to 95% No Condensation
Emulation Keyboard and Mouse

INSTALLATION DIAGRAM
HARDWARE INSTALLATION
1. Ensure that the power is disconnected from DVN-16Pro.
2. Connect the DVI cables, USB cables (male-A to male-B), and audio cables from the computers to the respective
ports on the DVN-16Pro.
3. Optionally connect RS-232 for control functions.
4. Connect the USB keyboard and mouse to the two USB ports labeled keyboard/mouse.
5. Optionally connect USB peripherals (flash drives, printers, etc.) to the “USB 2.0 OUT” ports.
6. Connect speakers to the Audio Out ports.
7. Connect the display monitor to the OUT DVI connector on the DVN-16Pro.
8. Power on the DVN-16Pro.
FRONT
REAR
COMMANDS HOTKEYS RS-232
Switch all devices (KVM, USB 2.0, and Audio) [CTRL] [CTRL] m [port #] [ENTER] //m[port #] [ENTER]
Switch KVM only [CTRL] [CTRL] c [port #] [ENTER] //c[port #] [ENTER]
Switch audio only [CTRL] [CTRL] a [port #] [ENTER] //a[port #] [ENTER]
Reset [CTRL] [CTRL] r //r
Switch USB 2.0 only [CTRL] [CTRL] u [port #] [ENTER] //u [port #] [ENTER]
Reload EDID (Toggle Hotplug pin) n/a //h [ENTER]
Same as front panel up arrow button [CTRL] [CTRL] ↑n/a
Same as front panel down arrow button [CTRL] [CTRL] ↓n/a
INTRODUCTION
The DVN-16Pro is a dedicated multi-platform KVM
switch capable of managing up to 16 different com-
puters through a single DVI-D monitor, USB keyboard
& mouse and a single set of speakers with USB 2.0
device sharing. The USB emulation technology utilized
by the DVN-16Pro enables immediate hotkey source
switching through a remote USB keyboard and
mouse. The DVN-16Pro provides high resolution, up to
1920x1200 with zero pixel loss from TMDS signal
correction.
FULL USB KEYBOARD AND MOUSE EMULATION
The DVN-16Pro imitates the presence of a keyboard
and mouse for every attached computer through its
USB cable. This is essential when switching.
FRONT PANEL CONTROL
To switch ports using the front panel, press either the
Enter button for up or the Scroll button for down to
select the port you would like to switch to. The se-
lected port number will be indicated on the LED dis-
play.
Pressing both the Scroll and Enter buttons simultane-
ously will display a menu on the LCD.
Press the Scroll button to move between the selec-
tions and the Enter button to execute the selection.
The selections are:
Learn Screen: Learn EDID from connected monitor.
Hot Plug: Resets a pin on the DVI connector causing
the DVN-16Pro to re-learn the connected monitor’s
EDID settings.
Exit: Exits Menu.