SMART Board 3000i User manual

Operating Instructions
Rear Projection Smart Board 3000i
1). Overview of the Smart Board Front Features:

-2-
2). Using the Pen Tray Stylus – The four colored styluses are not available, but
if you select one of the colored trays, you can write with your fingers on the
active SMART Board. The eraser (located in the cabinet) allows you to erase
what you wrote.
3). Using the Pen Tray Buttons – Press the top Pen Tray button to make the Smart On-
screen Keyboard appear for onscreen typing. Press the bottom button to make the
next contact with the Board a right-mouse click.

-3-
4). Control Panel Features:
The Control Panel allows you to adjust major aspects of the SMART Board
Display, as well as the volume of the internal/external sound system.
NOTE: Do not press Control Panel buttons in quick succession. If the projector is busy
Processing a request (indicated by the appearance of an hourglass), do not press another
Control Panel button until it has completed its processing.
àTo turn the Projector ON, press on the (5.Projector Standby Button). The green LED
to the immediate left of this button will flash indicating the lamp is in the process of
powering up. When the green LED remains a steady green then the lamp is on and
projector is operational.
àPress the (1.Display Source Button) to select the input display source for the projector.
Choose Internal Computer, VCR, or Laptop. Remember the NOTE above. Wait for the
hourglass to disappear before selecting another input. The LED to the right of this button
indicates the current display input.
àYou can adjust the Volume, Brightness and Contrast from the control Panel by
pressing the up and down arrows.
àTo power off the projector, press the (5.Projector Standby Button). This will put the
projector in standby mode. The LED will begin to blink slowly and this indicates that the
projector is in the process of powering down. This takes approximately 5 minutes. When
the LED is off, the projector is now off.
NOTE: DO NOT TOUCH THE REMOTE CONTROL IF YOU ARE HAVING A
PROBLEM. Contact Chris Singer at x.22761 or Otto Geiss at x.26967.