Smart Tweezers Colibri ST5C User manual

®
MODEL: Colibri ST5C
DISCHARGE CAPACITOR BEFORE MEASUREMENTS
Control Diagram
 Press the control buon to turn on.
 The device powers o automacally
if it not operaonal for 60 seconds.
Note: If the frequency is forced to 10KHz
the device might not power o automacally.
 To set both test frequency and measurement
funcon to AUTO press buon and hold it for
about 2 seconds.
AM and AF symbols appear on the display
 To change measurement funcon
press buon.
 To change test frequency press buon and
hold it for about 1 second
Note: Set C mode and 100Hz to measure
large value capacitors reliably.
Note: Set L mode and 10Khz to measure
small value inductors reliably.
AUTO AM
RES
IND
CAP
ESR
PRESS & HOLD LONGER THAN 1 SEC
PRESS TO WAKE UP
MODE
PRESS SHORTER THAN 1SEC
PRESS & HOLD L ONGER THAN 2 SEC
TO SET MODE AND TFREQ TO AUTO
10kHz
AUTO AF
1 kHz
100Hz
TEST
FREQ
Measuring with Colibri

®
MODEL: ST5S
®
MODEL: Colibri ST5C
10 kHz
PRIMARY
PARAMETER
AM AF
Rs= 53.01m
SECONDARY
PARAMETER
BATTERY
INDICATOR
COMPONENT
MEASUREMENT
MODEL
ACTUAL TEST
FREQUENCY
AUTO FREQUENCY
SETTING INDICATOR
AUTOIDENTIFICATION
SETTING INDICATOR
COMPONENT TY PE AND
MEASUREMENT FUNCTION
L 19.47uH
Display Layout
Measurement Funcons:
AM - auto idencaon of L, C or R
L - inductance + resistance
C - capacitance + resistance
R - Resistance
ESR - equivalent series resistance
Test Frequency:
AF - auto selecon of the test frequency
100Hz, 1kHz, 10kHz
Test frequency: 100Hz,1kHz,10kHz
Test signal level: 0.45Vrms, CW
Basic accuracy*: Resistors 0.5% (1% Rx<1Ω ; 0.5% 1Ω <Rx <5MΩ ; 1% Rx>5MΩ)
Capacitors** 1% (5% Cx<10pF ; 1% 10pF<Cx<5000µF ; 5% Cx>5000µF)
Inductance 1% (5% Lx<10µH ; 1% 10µH<Lx<500mH ; 5% LX>500mH)
Baery life: up to 20hours of connuous operaon
Charge me: up to 3hours, DC 5V, 50mA
Physical specicaon: Dimensions 148x20x15 mm,
Weight 29g, Operang temperature 0 - 50C
* opmal test frequency, oset subtracted from the result.
Typical oset for resistance - 0.035 Ohm, for capacitance - 0.3pF
** capacitors with Cx<5pF can be measured only with manual sengs.
p/n ST52CAD-IN2
Specicaons
Component Measurement Model:
Serial (Rs) or Parallel (Rp)