Smittybilt 5660224 User manual

Smittybilt G.E.A.R. Front Seat Covers - Coyote Tan
Installation Guide for Jeep Wrangler '07-'16 2-Door JK
Installation Time: <1 Hour
Tools Required:
Box Cutter/Knife (for opening the packaging)
Installation Instructions:
1. Remove the seat covers from the packaging (Figure A).
Figure A
2. Lay out each piece in the sun (this will help reduce wrinkling caused by the packaging) (Figure B).

Figure B
3. Remove the headrest (Figure C).
Figure C
4. Position the seat cover over top of the seat back with the Molle threading facing the rear of the vehicle (Figure
D).

Figure D
5. Slide the seat cover down the seat back, pulling on both ends (Figure E).
Figure E
6. Replace the headrest (Figure F).

Figure F
7. Pull each set of strings at the bottom tight and move the spring-loaded catch into place (Figure G).
Figure G
8. Begin installing the Molle system pockets by weaving the rear fabric straps through the Molle threading on the
backside of the seat cover (Figure H).

Figure H
9. Snap the fabric straps back into place (Figure I).
Figure I
10. Repeat Steps 3-9 on the other front seat.