SNBC BTP-2002NP User manual

123
A. Package contents
The parts that are mentioned hereafter are included in the
carton. Please contact our resellers if any parts are missing
or damaged.
B. About the HERALD
Exterior and structure（see figures below）
1—Light 2—Light pole 3—Top cover
4—MODE key 5—OK key 6—Bottom cover
7—Turn-plate 8—Bracket
C. Assembling the HERALD
Mounting of the bracket
Mount the metal bracket with two nylon feet and two screws
onto the bottom of the printer as shown in the following
diagram. Then mount the two remaining nylon feet onto the
bottom of the printer opposite the metal bracket (see
drawing)
BTP-2002NP BTP-M270 etc.
Mounting the Main Unit
Step 1: Insert the Main Unit in the plastic turn-plate of the
Bracket as shown in Figure 1.
FIGURE1 FIGURE2
Step 2：Rotate the Main Unit clockwise as shown in figures
2 and 3 if the printer is to be used on a horizontal surface. If
the printer is mounted on a vertical surface by means of our
Wall Mount System then the Main Unit should be rotated
anti-clockwise.
FIGURE3 FIGURE4
Step 3：After you have ensured that the printer is switched
off, the Main Unit can be connected to the Cashdrawer
connector at the back of the printer as shown in figure 5.
FIGURE 5
D. Printer key-pad
The printer module has two keys: MODE key and OK key.
The HERALD has two modes, called “Operation” and
“Setting”. The operation mode is used for operating the
HERALD; the settings mode is used for setting the optical
and acoustic signals of the HERALD. When the printer is
switched on after connecting the HERALD, a test
procedure will start and the HERALD will give a short beep
and a brief light flash. This indicates that the HERALD is

45
connected properly and that the HERALD is in the
Operation mode.
E. Operation mode and Setting mode
Operation mode
When you want the HERALD to function with the printer,
you should select in the printer driver of the BTP-2002CP
printer “Cash Drawer #1 Waiting 40ms” or if the
BTP-2002NP printer is used “Order Messenger”. Above
setting can be selected in the printer driver by going
through the following steps: “General” “Printing
Preferences” “Advanced” “Document options” “Media”. The
HERALD will give an optical and/or an acoustic signal. To
disable the HERALD function, you need to select “No
Cashdrawer” in printer driver.
Setting mode
The setting mode is used to change the optical and
acoustic signals of the HERALD.
1. You can choose the setting mode by pressing and
holding down the MODE key while switching on the
printer. After releasing the MODE key you will hear a
short beep.
2. Modifying the settings. By pressing the MODE key
repeatedly you can switch between the modes Volume
for setting the volume of the beeps, Optical for setting
the number of light flashes and Acoustics for setting the
number of beeps. The modes are indicated by the
number of light flashes given by the HERALD; Volume =
1 flash, Optical = 2 flashes, Acoustics = 3 flashes.
You can choose the mode by pressing the OK-key. By
than pressing the MODE-key you can go through the
choices of that mode. The choice is made by pressing
the OK-key. By pressing the MODE-key briefly you will
move to the next mode.
3. Save settings. You can save all settings by pressing the
MODE-key for longer than 3 seconds. After a short beep
you can release the MODE-key.
4. After switching the printer OFF and ON again, the
settings are permanently saved until you change the
settings again.
Operation Guide
HERALD – kitchen alarm system
Contents
A.Package contents................................................1
B.About the HERALD.............................................1
C.Assembling the HERALD....................................1
D.Printer key-pad....................................................3
E.Operation mode and setting mode......................3