Solarland Portable Series manual 

SLCK040-12，SLP080F-12S，SLP120F-12S
INSTRUCTIONS & HANDBOOK Assembled in the USA!
The Solarland Portable Series is
designed to charge 12V Lead-Acid,
GEL and AGM style batteries.
Kit Contents:
80W&120W Model:2 x 40W/60W Solar Panels
(Hinged together, with adjustable legs & handle)
40W Model: One Single 40W Portable Panel with
adjustable legs & handle
1 x Carry Case
1 x 10A Solar Charge Controller
5m Cable with Weather-Pack Connector 1 x Bat-
tery Clamp Adapter with Weatherproof Connector
1 x RTA Assembly with Weather-Pack Connector
1 x Car Style Cigarette Connector(on 80W and
120W model Only)
Important Safety Information:
•Read and follow all instructions carefully. Charge Controller instructions are provided
separately.
•Do not submerge unit, or any part thereof in any liquid.
•Do not operate in wet environments or leave in rain or snow.
•Use warm water and soft rag to clean panels. Do not use abrasive cleaners.
•Keep away from children. Keep close supervision when children are present.
The Solarland Portable Series is a simple
“Plug & Play” design.
The 2 x (40W/60W) panels come attached in
parallel and are cabled to the controller. 40W
Portable comes in one single 40W solar panel.
A 5m cable comes attached to the controller
with a Weather-Pack Connector.
A battery Clamp Adapter and Ring Terminal
Adapter are provided as standard.

Ring Terminal Adapter:
The RTA adapter is designed for a permanent
connection on one end to the battery, and a
quick disconnect on the other to the control-
ler.
Perfect when batteries are hard to access and
the convenience of a quick disconnect is
required.
The RTA Adapter is fitted with the Weath-
er-Pack Connector for quick connection to
the 5m cable from the controller.
Battery Clamp Adapter
The battery clamp adapter is fitted
with the Weather-Pack
Connector for quick disconnect
with the 5m cable from the con-
troller.
Weather-Pack Connector:
Weather-pack connector bodies are
locking nylon and sealed against mois-
ture, dust and dirt. Locking design pro-
vides a weather-tight connection.
Folding Legs:
Each panel has a folding leg with non-slip
rubber boots.
Adjusting straps are provided to ensure a
secure angle adjustment stays in place.
Installation & Connection:
•Cover the panels while connecting the battery clamps, attach clamps and then remove
the cover exposing the panels to the sunlight. The battery charging will start within a
few seconds after the controller has run through its ‘self-check’ procedure.
•Place the unit in a location with maximum sun exposure – full sun all day – for best
performance.
•In the northern hemisphere you will need to be facing in a southerly direction.
•Keep panels free from shade and any kind of obstructions that may affect the sunlight
getting to the panels.
•Keep panels free from debris such as leaves and dust.
•Do not place in long grass as this will cause shading on the solar cells at the bottom of
the panels. A minimal amount of shading can have a large, negative affect on the panel
performance.