Solo TS5010 User manual

Quick Start
Guide
Starting Out
When you rst get started, this is
how your cart will look. The rest
of this guide will explain getting
from here to cleaning windows.
Attach Bypass
Attach the bypass hose assembly
to the male brass bypass tting on
the output side.
READ THIS
Read this guide before using
your system. Failure to follow
these directions voids all
warranties.
View the quick start video:
www.abcwindowsupply.com/soloquickstart

Quick Connect
Screw the quick connect with shut
o to the system outlet.
Insert Pole Tubing
Turn Quick Connect valve to o.
Plug in pole tubing to Quick Connect.
Open valve on Quick Connect.
Attach Source
Hose
Connect source hose to system
inlet.

Turn On Water
Close your bypass valve
completely.
(Note: see manual for more detailed
instruction on bypass operation.)
At least some water will be coming
out at all times while in use.
Adjust Bypass
Open the RO bypass to fully open
position.
Place open end of bypass hose
so that water ows to a desirable
location. Weigh down end if
necessary.
Turn on source water.
Clean Windows
Enjoy your Solo System!

Disconnect source hose and pole
tubing.
Tip the system with inlet side up
and allow water to drain out of the
bypass.
Shut quick connect and attach the
outlet of the bypass to the system
inlet for water tight transport.
1. Shut o ow of pure water to
brush.
2. Fully open bypass. Allow bypass
to ush the system out for 3–5
minutes.
Shut Down Procedure 2
Shut Down Procedure 1
Optional
If your source water is over 200
TDS, or your output is over 10 TDS,
add a DI lter such as the Rover.
We recommend using 1/2” hose.