SonicWALL SRA EX9000 User manual

SRA EX9000 Power Supply Installation
Guide
This document provides instructions for removing and installing a
replacement power supply. The SonicWall SRA EX9000 contains two
designated ports on the back bezel for power supply modules. The dual
power supply ensures redundancy if one power supply fails.
Removing the Power Supply from the SRA
Appliance
To remove a defective power supply from the SRA appliance:
1 Verify that one of the Power LEDs on the front bezel is red. The LED
turns red if the corresponding power supply has failed or is
unplugged.
2 Unplug the power cord of the module you wish to remove. There is
no need to power down the appliance.
3 Use a Phillips screwdriver to loosen the two screws holding the
module in place, until the screws detach from the chassis.
4 Note the orientation of the power supply. Pull the entire power
supply module out of the appliance using the attached handle, and
set it aside.
Inserting the Power Supply into the SRA
Appliance
To insert the new power supply into the SRA Appliance:
1 Insert the power supply into the empty slot, using the same
orientation you noted when you removed the power supply.
2 Firmly push the module in and fasten the screws with a Phillips
screwdriver.
3 Plug in the supplied power cord.
4 Verify that the Power LED changes to blue, indicating that the new
power supply module has been successfully inserted and
connected.

This Power Supply, 01-SSC-9598 SONICWALL E-CLASS SRA EX9000 POWER
SUPPLY, is intended only for the appliance indicated below:
01-SSC-9574 - SONICWALL E-CLASS SRA EX9000
Use of this module with a SonicWall appliance that is not approved will void the
warranty for that appliance.
For information and related documents, see the following web site:
https://www.sonicwall.com/support
Copyright © 2019 SonicWall Inc. All rights reserved.
SonicWall is a trademark or registered trademark of SonicWall Inc. and/or its affiliates in the
U.S.A. and/or other countries. All other trademarks are property of their respective owners.
The information in this document is provided in connection with SonicWall Inc. and/or its
affiliates' products. No license, express or implied, by estoppel or otherwise, to any
intellectual property right is granted by this document. SonicWall Inc. and/or its affiliates do
not make any commitment to update the information contained in this document. For more
information, visit http://www.sonicwall.com/legal.
SRA EX9000 Power Supply Installation Guide
Updated - August 2019
232-003467-51 RevA
Legend
WARNING: A WARNING icon indicates a potential for property damage,
personal injury, or death.
CAUTION: A CAUTION icon indicates potential damage to hardware or loss of
data if instructions are not followed.
IMPORTANT, NOTE, TIP, MOBILE, or VIDEO: An information icon indicates
supporting information.
SonicWall®SRA
EX9000 Power Supply
Installation Guide