Sony Ericsson T200 User manual

Trouble Shooting Guide, Electrical
4/00021-2/FEA 209 544/71 B
Sony Ericsson Mobile Communications AB
Approved according to 000 21-LXE 107 42/1
Trouble Shooting GuideT200, Electrical
Contents
1Explanations ....................................................................................................................2
1.1 Service functions in the software................................................................................2
2Network Problems ..........................................................................................................3
3On/Off Problem...............................................................................................................4
4Display / Illumination Problems ....................................................................................5
5Charging Problems .........................................................................................................6
6LED Problems .................................................................................................................7
7Alert Problems ................................................................................................................8
8Microphone Problem ...................................................................................................... 9
9Real time clock problem...............................................................................................10
10 SIM Card recognition Problem ...................................................................................10
11 Revision history.............................................................................................................12
All manuals and user guides at all-guides.com
all-guides.com

Trouble Shooting Guide, Electrical
4/00021-2/FEA 209 544/71 B
Sony Ericsson Mobile Communications AB
2(12)
1 Explanations
For Component replacement refer to doc. Component List.
The Go / No Go test has to be performed with a mounted phone.
1.1 Service functions in the software
In the software of the phone there is a built in service function that allows testing some of the
functions of the phone.
They are as follows:
• Service info
• Service settings
• Service tests
• Text labels
To use the function press the following combination, using the naviation button and the
keyboard: > * < < * < *
All manuals and user guides at all-guides.com

Trouble Shooting Guide, Electrical
4/00021-2/FEA 209 544/71 B
Sony Ericsson Mobile Communications AB
3(12)
2 Network Problems
• Check the Antenna Units flex film is properly fitted and undamaged.
(Fig2.1) Also check the connectors on the antenna unit.
Replace the Antenna unit if it’s necessary.
Also check the PCB pads, if necessary clean them.
• Check the External Antenna Connector (Fig2.2) if it’s incorrectly soldered,
mechanically damaged, dirty, deformed or oxidized. Measure the resistance through the
Antenna Connector; it should be less than 1Ω.
Replace Antenna Connector if it’s necessary.
If fault still remains, send the unit to higher level according to local company directives.
Fig. 2.1 Fig. 2.2Fig. 2.2
All manuals and user guides at all-guides.com

Trouble Shooting Guide, Electrical
4/00021-2/FEA 209 544/71 B
Sony Ericsson Mobile Communications AB
4(12)
3 On/Off Problem
• Check that the telephone battery connector if it is incorrectly soldered,
mechanically damaged, dirty, deformed or oxidized (Fig. 3.1).
Replace battery Connector if necessary.
• Make sure that the battery is working properly.
Replace battery if necessary.
• Make sure that the keypad is not damaged.
Replace keypad if necessary.
• Make sure that the system connector is not damaged
Replace system connector if necessary.
If fault still remains, send the unit to higher level according to local company directives
Fig. 3.1
All manuals and user guides at all-guides.com

Trouble Shooting Guide, Electrical
4/00021-2/FEA 209 544/71 B
Sony Ericsson Mobile Communications AB
5(12)
4 Display / Illumination Problems
• Check the LCD Zif connector if it’s (Fig. 4.1) if it’s incorrectly soldered,
Mechanically damaged, dirty or oxidized.
Replace it if necessary.
• If the LCD connector is OK, replace the Display assembly (Fig 4.2)
If fault still remains, send the unit to higher level according to local company directives.
Fig. 4.1
Fig. 4.2
All manuals and user guides at all-guides.com