Sony XR-C2200 Product guide

FM/AM
Cassette
Car Stereo
Installation/Connections
XR-C2300X
XR-C2200
Sony Corporation © 2000

Parts list
The numbers in the list are keyed to those in the instructions.
O® @ ®
® ®
×4
®®
The release key (_) is used for dismounting the unit. See the Operating Instructions manual for details.
Cautions
* Cautionary notice for handling the bracket O.
Handle the bracket carefully to avoid injuring your fingers.
°Remove the protection collar @before installing.
Release the catch lock as illustrated.

Installation
Precautions
*CJhoo_ the i_st, m_a_ o_ l_ hOl'Lcmreft;I]y so that the _lt will not intel'ferB wzth tloz1_al dri_blg.
•Avoid insta[N ng the urdt i_ ar_as subject to d use, dirt, _slve vibration, or hJ _temperatures, su_ _s
in dirge _u_li_,ht or neBr h_ater duct_.
• Use only the _upplt_l mo_n_ J_ardware _F a safe and s_cu_-e instaUatlon.
Mounting angle adjustment
Adjust the mounhng ang[_ to le_ ban __0_.
I
How to detach and attach the front panel
Before InstaUlng the unit, detach the front panel.
[] To detach
Before de _c)_iz_ t_e Ero_t p_e[, b_ su_ to pros _, J_re_s _, then slide the fr_t panel a
JJ_tle to the leh. and pull it _ff to'-va='d s you.
[] Ta attach
Attach part _) of the £ront peunel to p_rt _) of the u_it a_ ill ustr_t_l _d push the J_ft _de into po_it_on
tt_tlJit¢l_ck_.
Mounting example
In_lla_lon Ir_ tl_ dashboard
12
bo . t
Ught f_..f n ry
Plier m griff_s po_t assu mr
un_ prm_ _orrl_t_ si n_c_ms_ ir_
Mounting the unit in a Japanese car
YOU ma)_ _)t be able to bast;sit _u_nlt in r,onle _ake_ of ]'a]_anese _:a_ I_ -'.ocha_se, _onsult yo_" _,_ny
d_aler.
TOYOTA ®
m_x. size
S xB rain
D_si_n
Sxgmm
NISSAN
N_
To Ixev_nt tn_ffu_on, let.trail only _vlth the _;.,Ipplied $crev*_ _._.

Installation
3Dashboard
Tableau de bord
®
With the UP mrklng up
Avgc I'inscriptLon UPvmr_ le halt
Fin_ wall
parol ig nifugl
NISSAN
max slz_
5×Emm

Connections
Caution
•This unit isdesigned for negative ground 1-°V DC operation only.
•Becareful not to pinchany wires between ascrew and the body of the caz or this u_t or between any
moving i_rt_ such as fl_eseatrailing, etc.
•Before malting connections,di_onnect the ground terminal of the car battery to avoid short drcuits.
• Connect _e yellow and red power input teaclsonly after all other leads have been connected.
• Besureto connect the red power input lead to the positive 12 V power terminal which i_ energized
when the tgni_on _isin the acc_ssozT,_it_on.
° Run all ground wires to a common ground point.
• Connect bheye_ow cord to afree car cLrc_t rated higher than the unit's fuse z_lzng. If you connectthis
unit Jn serie_with other stereocomponents, the car circuit the" are connectedto must be rated higher
than the sum of the individua) component's fu_e rating. If there are no car circuits rated a_high asthe
unit's fuserating, coz_nectthe unit directly to _e battery. If no car c_rcuiteare av_lable for cormecl_ng
this unit, connectthe unit to a car cLrcuitrated hi._ er than the u_t'_ fuse rating in sLtChaway thatif the
unit blows its fu_e, no other circuitswill becut off.
Warning when installing in a car without ACC(accessory)position on
the ignition keyswitch
Besure to press (_ on the unit for two seconds to torn off the clock display aSter turned off the
engine.
When you press _momentarily, the dock d_spl_y does not turn off and th_s causes batten, wear,
Reset button
When the L_st_[at_on and connections are complete, be sure to p_s the reset button with a ball-point
pen, etc.
Notes of connection example
Notes on the €ontm/and povRr supp/y leads
•l_e power antenna control lead (blue) supplies +12 VDC when you turn on the unit.
•When your car has abuilt-in FM/AM antenna in the rear/side glass, it isnecessary to connect the power antenna
control lead (blue) or the accessorypower input lead (red) to the power termina I of the extsTing antenna boosten
For details, consult your deale_
•A power antenna Without arelay box cannot be u_ed with th_ uni_
Memo_ hold connection
When the yellow power input lead is €onn_cte_ power wi# always be rupplled to th_ memory circuit even when
the ignition switch i_ turned of_
Notes on speaker connecdon
•Before connecting the speaker;, turn the unit off.
•U_e speakers with an impedance of 4 to 8 ohn_. and with adequate power handling ,apecltle_ Otherwise, the
speaker may be damagect
•Do not connect 11_ terminals of the _peaker system to the car chassis, and do not connect the terminals of the
right speaker with those of the le_ speaker.
•Do not attempt to _onnect the zpeaker_ it_parallel.
•DO not connect any _tfve speakers (with buitt_n amplifien) to the speaker terminals of the unit. Doing so may
damage the active speakers. Be _ure to connect pesdve speakers to these terminals.

Connection example
Supplied
Foumi a
!
IXR-C2300X
XR-C2200
Fuse (10 A)
Fusible (10 A)
White
Gauche
Gray
Gauche
__ Purple
Mauve
c_t
to the +12 V power terminal which is energi_ed at all times Yellow
Be sum to conned the black ground lead first. _Jaune
Blue/white striped
Ray_ bleu/b_an(
_ue
Bleu
Red
_. Rouge
to a me_.al place in the car
first connect the black ground lead, then connect the _Black
yellow and _power input leads, r_ Noir

Supplied with XA-a0
Foumi av_ le XA-C]0
\Suppl_-_l with the CD/M D changer
Foumi avec le thangeu r de CDIMD
ft'ont a (ar alltlL_ln_
de I'antenne de bs voltum
Blue/white striped
Pray6bleu/blanc
RCAgin cord (not supplied)
Cordon a broche RCA (non foumi)
AMP REM
Max, supply ¢uRent 03 A
Courant ma_ fouml 0,3 A To AMP REMOTE IN of the optional power amplifier
Thisconnection isonly for amplifiers. Connecting any other system may
damage the unit.
BIU_
Bleu ANT REM
M_. supply current 0.1 A
Courant max. fourni 0,1 A
to the powlr armmna control kind or power supply kind of antenna
booster amplWmr
Notes
•It isnot necessaryto connect this lead if there is no power antenna or
antenna booster, or with amanually<>perated tele_opi_ antenna.
•When your car has a built-in FM/AM antenna in the reariside glass, see
..._._ "Notes on the control and power supply leads."
Red
Rouge O
to the +12 V power terminal which isene_jized nt the accessory position of
the ignition key switch
Notes
•ff there isno accessoryposition, connect to the +12 Vpower (battery)
terminal wh_J_ isenergized at all ames.
Be sure to connect the black ground to It ftrst.
•When your car has abullt-ln FM/AM antenna in the reariside glass,see
"Notes On the ,ontrol 8nd power supply le_d$."

Connection diagram
Equipment used in illustrations (not supplied)
Appareils utilis#s clans les illustrations (non fournis)
Fron t |p#kerHiut-pa dgur frontal power amplifier Arnpl_ical_ur de puimnce
Rear sl_ak_r
Hau_pafleurl_imm ¢D/MD changer Chmng_r de CD/MD
FOr connecting two Dr mole cha_r_, th_ source Se_r XA-C_O (_o_i_nal) J, n_esx_ry.
Pans le ,_s du raccordernent de deux ¢l_n_u_ ou plus. le s_cteur de source XA-C30 _ptionnel) _t
indispenxable.
Q
Q
No_e5
-Be sure to conne_: the ground cord before connecting the amplifier.
oIf you _nr_ect _n optional _ver arnp_f_r _ncl do not us_ the built-in t)mplifler, the beep sound will
¢l*ta_ivefe_
Remarqu_
4p.ac_'ordez d'_bo_ I_ 1_1d_ n_asse avant de _nn_er I'_n_plifi_ateu_
b_p sor_r_ _st d_u_tive.
B
0

Sony Corporation Printed in USA SonyOline http://www.world.sony.com/