DVP-S336/S345/S360/S365/S560D/S570D/S745D
SECTION 4
PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For printed wiring boards:
•X: indicates a lead wire mounted on the component
side.
•x:indicates a leadwiremountedontheprinted side.
•a:Through hole.
•b: Pattern from the side which enables seeing.
(The other layers’ patterns are not indicated.)
For schematic Diagram:
• Caution when replacing chip parts.
New parts must be attached after removal of chip.
Be careful not to heat the minus side of tantalum capacitor,
because it is damaged by the heat.
• All resistors are in ohms, 1/4W (Chip resistors :1/10 W) un-
less otherwise specified.
kΩ:1000Ω, MΩ: 1000kΩ.
• Allcapacitorsarein µF unless otherwise noted. pF: µµF
50V or less are not indicated except for electrolytics and
tantalums.
• Allvariableandadjustableresistors havecharacteristic curve
B, unless otherwise noted.
•2:nonflammable resistor.
•5:fusible resistor.
•C: panel designation.
•f:internal component.
•C:adjustment for repair.
•U: B+ Line.
•V:B– Line.
• Circled numbers refer to waveforms.
• Voltages are dc between measurement point.
• Readings are taken with a color-bar signals on DVD refer-
ence disc and when playing CD reference disc.
• Readings are taken with a digital multimeter (DC 10MΩ).
• Voltage variations may be noted due to normal production
tolerances.
Caution:
Pattern face side: Partsonthepatternfaceside seenfrom
(Side B) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Side A) theparts face are indicated.
Whenindicatingparts byreference
number, please include the board
name.
• Abbreviation
CH : Chinese
CND : Canadian
HK : Hong Kong
KR : Korea
SP : Singapore
• Abbreviation
CH : Chinese
CND : Canadian
HK :Hong Kong
KR : Korea
SP : Singapore
4-1
Note:
The components identi-
fied by mark 0or dotted
linewithmark0arecriti-
cal for safety.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque 0sont critiques
pour la sécurité.
Ne les remplacer que par une
pièce portant le numéro
spécifié.