Sony XS-F1021 User manual

S 01'_'_, 3-o,o-1o3.,,i,i
lOcm Coaxial
2.way Speaker
Instructions
XS-F1021
Sony Corporation © 2000

Precautions
•Do not continuously drive the speaker system
over the power handling capacity.
•Keep recorded tapes, watches, and personal
credit cards using magnetic coding away from
the speaker system to protect them from
damage caused by the magnets in the
speakers.
If you cannot find an appropriate mounting I
location, consult your car dealer or your Inearest Sony dealer before mounting.
Before Mounting
• A depth of at least 49.3 mm (2 in.) is required
for mounting the woofer. Keep the following
in mind when choosing a mounting location.
• A hole may already be provided in the metal
frame of the front door.
•Nothing should interfere with the speaker
inside the door,
•The speaker inside the door must not come
into contact with the window when it is open.
• Be careful that speakers are out of the way of
the window cranks, door handles, and arm
rests.
If you cannot find an appropriate mounting
location, check with your car dealer or
consult the nearest Sony dealer.

Mounting
Parts List
O @ ®
O2.5 m (98 1/2in./po.) ×2 M4 ×40 x8
Mounting example
Mark the four bolt holes. Make them 3.3 mm •(%_ in.) in diameter.
_= 5 mm (Ih2 in. )
-) 104 mm (4 llj in .)
3
*White cord -- Left speaker
Gray cord -- Right speaker
Black-striped cord 4

x8
®
x8
® ®
x2 x2
Remove the grille net..
r
®
4Speaker
Door panel
R

Gray cord -- Right speaker \I Power amplifier, etc. J
Press and insert the edges of the grille net.
Flat mounting (installed flush with the surface of the dash)
8
/_91 mm (3 V, in, _

Doorpanel
How to remove the grille net
t
This speaker can be made to fit almost any type of
car by removing the moun_ng tabs.
Use clippers or pliers, etc. to cut or snap the
mounting tabs off so that it iseven with the
edge of the speaker frame as illustrated.
Notes
After removing the mounting tabs, handle the
speaker frame with care, as the edges may be sharp.
7

Specifications
Speak_
Maximum input power
Rated input power
Impedance
Sensitivity
Frequency response
Mass
Coaxial 2-way:
Woofer 10 cm (4 in.),
polypropylene cone type
Tweeter 2.5 cm (1 in.), PEI,
balance dome type
80W
25 W
4 ohms
89 dB/W/m
45 - 30,000 Hz
Approx. 480 g (1 lb. 1 oz.)
per speaker
Design and specifications are subject to change
without notice.
Dimensions * Mounting depth
___ 16.5 (zl/a2)
1
_J
_,e)
49.3 (2)* Unit: mm (in.)
Sony@line http_/www.world.sony.com/
SonyCorporation Printed in USA