Sony HTC-V5550 User manual

HTC-V5550
E Model
Chinese Model
SERVICE MANUAL
COMPACT DISC DECK
MICROFILM
This stereo system is equipped with the Dolby B-
type noise reduction system.
* Manufactured under license from Dolby
Laboratories Licensing Corporation.
DOLBY, the double-D symbol aand “PRO LOGIC”
are trademarks of Dolby Laboratories Licensing
Corporation.
Model Name Using Similar Mechanism HCD-V717
CD CD Mechanism Type CDM38-5BD24
Section Base Unit Type BU-5BD24
Optical Pick-up Name KSS-213BA/F-NP
Tape deck Model Name Using Similar Mechanism HTC-W555
Section Tape Transport Mechanism Type TCM-230AWR2
TCM-230PWR2
• This set is the deck and Video CD
section in MHC-V5550/V7770.
SPECIFICATIONS
Video section
Inputs AV INPUT VIDEO (phono jack):
1Vp-p, 75 Ω
VIDEO IN (phono jack)
1Vp-p, 75 Ω
Outputs MONITOR OUT (phono jack):
1Vp-p, 75 Ω
VIDEO OUT (phono jack)
1Vp-p, 75 Ω
S-VIDEO (4-pin/mini-DIN jack):
Y: 1Vp-p, unbalanced, sync negative
C: 0.286Vp-p, load impedance 75 Ω
VIDEO CD/CD player section
System Compact disc, digital audio video system
Laser Semiconductor laser (λ=780nm)
Emission duradon: continuous
Laser output Max. 44.6µW*
*This output is the value measured at a
diatance of 200 mm from the objective
lens surface on the Optical Pick-up Block
with 7 mm aperture.
Frequency response 20 Hz – 20 kHz (±1 dB)
Wavelength 780 – 790 nm
Signal to noise ratio More than 90 dB
Dynamic range More than 90 dB
Video Color System format
NTSC, PAL
CD OPTICAL DIGITAL OUT
(Square optical connector jack, rear panel)
Wavelength 600 nm
Output Level –18 dBm
Tape player section
Recording system 4-track 2-channel stereo
Frequency response 40 – 13,000 Hz (±3 dB),
(DOLBY NR OFF) using Sony TYPE
cassette
40 – 14,000 Hz (±3 dB),
using Sony TYPE
cassette
Design and specifications are subject to change without notice.

HTC-V5550
6-4. SCHEMATIC DIAGRAM — CD SECTION — • Refer to page 55 for Waveforms.
• Refer to page 58, 59 for IC Block Diagrams.
— 27 — — 28 —
(Page 51)
N
16
BS
The components identified by
mark!or dotted line with mark
!are critical for safety.
Replace only with part number
specified.

HTC-V5550
6-5. SCHEMATIC DIAGRAM — DECK SECTION — • Refer to page 59 for IC Block Diagrams.
— 29 — — 30 —
16
MAIN BOARD
CNS101
(Page 36)
The components identified by
mark!or dotted line with mark
!are critical for safety.
Replace only with part number
specified.

HTC-V5550
6-8. SCHEMATIC DIAGRAM — MAIN (1/2) SECTION —
— 35 — — 36 —
(Page 46) (Page 46) (Page 51)
(Page 40)
(Page 30)
2.6
6.9
3.3
6.9
3.3
3.4
4.9
3.1
(Page 52)
• Refer to page 59 for IC Block Diagrams.

HTC-V5550
6-9. SCHEMATIC DIAGRAM — MAIN (2/2) SECTION — • Refer to page 33 for Printed Wiring Board.
• Refer to page 60 for IC Pin Function Description.
— 37 — — 38 —
(Page 43) (Page 43) (Page 43)
The components identified by
mark!or dotted line with mark
!are critical for safety.
Replace only with part number
specified.

HTC-V5550
6-11. SCHEMATIC DIAGRAM — LEAF SW SECTION —
• Refer to page 16 for Circuit Boards Location.
6-10. PRINTED WIRING BOARD — LEAF SW SECTION —
— 39 —
MAIN BOARD
CNS104
(Page 36)
16
16
MAIN BOARD
CNS104
(Page 33)
— 40 —

HTC-V5550
6-13. SCHEMATIC DIAGRAM — PANEL SECTION —
— 43 — — 44 —
(Page 37)
(Page 37)
(Page 37)

HTC-V5550
6-14. SCHEMATIC DIAGRAM — CD MOTOR SECTION —
— 45 — — 46 —
MAIN BOARD
CN112
(Page 35)
MAIN BOARD
CN111
(Page 35)
16
• Refer to page 59 for IC Block Diagrams.

HTC-V5550
6-17. SCHEMATIC DIAGRAM — VIDEO (1/2) SECTION —
— 51 — — 52 —
(Page 27)
(Page 35)
(Page 36)
• Refer to page 61 for IC Pin Function Description.
• Refer to page 55 to 57 for Waveforms.

HTC-V5550
6-18. SCHEMATIC DIAGRAM — VIDEO (2/2) SECTION —
— 53 — — 54 —
2.6
• Refer to page 49 for Printed Wiring Board. • Refer to page 55 to 57 for Waveforms.
• Refer to page 59 for IC Block Diagrams. • Refer to page 64 for IC Pin Function Description.