Sony VPCJ111FX Guide

VPCJ1 Series Hard Disk Drive
Replacement Instructions
P/N 989201986 Rev. B 1/3
Hard Drive
Assembly
Hard Drive Removal
(Steps 2-6)
Step 2. Using the enclosed magnetic
screwdriver, remove the four (4) screws
securing the stand.
Put aside the Stand Screws to re-
secure the Stand later in the
procedure.
Prepare the Computer
CAUTION:Make sure the
computer is turned off, and the AC
Adapter is disconnected. Failure to do
so can result in damage to the
computer.
Step 1. Place the computer upside down
on a protected surface with the front
edge facing you.
Step 3. Grasp the stand handle and
pull upwards to remove the stand.
These easy instructions will guide you through the Hard Drive replacement process.
Before you begin, place your computer on a clean or covered surface to avoid damage to the
computer s case.*
Follow the ESD (Electrostatic Discharge) damage prevention instructions:
oHold parts by the edges, away from exposed circuitry when possible.
oDo not walk around excessively as this promotes static build-up.
Before you begin, remove any jewelry you may be wearing to prevent scratches to the surface
of your computer.*
The appearance of the electronic components shown in the illustrations may differ from the
components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for damage caused by incorrect handling of the computer.
IMPORTANT!
PLEASE READ BEFORE YOU START
Stand

VPCJ1 Series Hard Disk Drive
Replacement Instructions
P/N 989201986 Rev. B 2/3
Step 4.
Using the enclosed magnetic
screwdriver, loosen the three (3) screws
securing the Hard Drive Assembly.
These screws can not be completely
removed. They will stay enclosed in
the assembly.
Step 5.
Grasp the sides of the Hard
Drive Assembly and lift. Do not
completely remove the assembly at
this step.
Step 6.
Carefully turn the Hard Drive
Assembly over to disconnect the Data
and Power Cables from the assembly.
To release the Data Cable, push the
metal tab and pull the Cable to the
right. To release the Power Cable just
pull to the right. Remove the assembly.
Step
7
.
Identify the (4) side screws that
secure the bracket to the Hard Drive.
Step
8
.
Holding the edge of the Hard
Drive, remove each screw. Put aside
the Bracket Screws to secure the
Bracket to the Hard Dive later in the
procedure.
Step
9
.
Set the old Hard Drive aside.
Step 12. Re-install the four (4) Hard
Drive Bracket screws to secure the
Hard Drive bracket to the New Hard
Drive.
Step
10
.
Place the new Hard Drive next
to the Hard Drive Bracket as shown.
Step
11
.
Place the Hard Drive bracket
over the new Hard Drive.
Hard Drive Disassembly
(Steps 7-12)
Lift To Remove
Old Hard Drive
N
ew Hard Drive

VPCJ1 Series Hard Disk Drive
Replacement Instructions
P/N 989201986 Rev. B 3/3
H
ard Drive Reinstallation
(Steps 14-18)
Step 13. Reconnect the Hard Drive
Cables.
Step 14.
Carefully turn the Hard Drive
Assembly over, and insert it into the
Hard Drive Bay. Hold the Hard Drive on
the sides to avoid damage.
Step
15
.
Re-install the three (3) Hard
Drive Screws holding the Hard Drive
Assembly in place.
Step 18. Reconnect the AC Adaptor.
Power on your computer and continue
with the recovery process by following
the instructions described on the back
of the recovery disk’s case.
Return the old Hard Drive to
Sony using the included
shipping instructions.
Step
1
6
.
Re-install the stand. Verify the
sides are completely flush after
installation.
Step
17
.
Re-install the four (4) Hard
Drive Screws to secure the stand.