SORINEX P09197 User manual

ASSEMBLY INSTRUCTIONS
SORINEX.COM| |1 of 3
Bolt Together Flat Utility Bench
ASSEMBLY INSTRUCTIONS
DISCLAIMER:
RESISTANCE TRAINING, GYMNASTICS TRAINING, AND ACTIVITIES AT
HEIGHT ARE POTENTIALLY DANGEROUS AND MAY LEAD TO SEVERE INJURY
OR EVEN DEATH. THIS EQUIPMENT MUST BE USED BY COMPETENT AND
RESPONSIBLE PERSONS OR UNDER THE GUIDANCE AND SUPERVISION OF
COMPETENT PERSONS. BE SURE YOU ARE VERSED IN PROPER
TECHNIQUE AND METHODS BEFORE USING ANY EQUIPMENT. THE
USER ASSUMES ALL RISKS AND RESPONSIBILITIES FOR ALL DAMAGE,
INJURY OR DEATH WHICH MAY OCCUR DURING INCORRECT USE OF THIS
EQUIPMENT. SORINEX BEARS NO LIABILITY ABOVE REPLACEMENT VALUE
OF THE EQUIPMENT IN QUESTION. BENCH COULD WOBBLE IF FLOOR IS
NOT PERFECTLY LEVEL.
Sorinex Exercise Equipment | 193 Litton Drive | Lexington, SC 29073 | 1-877-SORINEX | [email protected]
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF SORINEX INC.
ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SORINEX INC. IS PROHIBITED.
START BY LAYING BENCH SPINE DOWN ON A FLAT SURFACE.
(AS SHOWN)
ALIGN BENCH FLANGES TO SPINE AND HAND SECURE WITH 5/8”
HARDWARE. (AS SHOWN)
TOOLS NEEDED:
1/2” WRENCHS
15/16” WRENCHS
1. 2.

ASSEMBLY INSTRUCTIONS
SORINEX.COM| |2 of 3
Sorinex Exercise Equipment | 193 Litton Drive | Lexington, SC 29073 | 1-877-SORINEX | [email protected]
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF SORINEX INC.
ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SORINEX INC. IS PROHIBITED.
REPEAT STEPS FOR OTHER SIDE. ALIGN BENCH BASE TO FLANGES AND HAND SECURE WITH
HARDWARE. SORINEX BRANDING SHOULD FACE OUTWARD.
REPEAT STEPS FOR OTHER SIDE. SLIDE ON RUBBER FEET TO BENCH BASE. (AS SHOWN)
APPLY PRESSURE IN DIRECTION SHOWN. WHILE PRESSURE IS
APPLYED, SECURE ALL 5/8” HARDWARE WITH 13/16” WRENCHS.
TURN OVER BENCH TO STANDING POSITION.
3. 4.
5. 6.
7. 8.

ASSEMBLY INSTRUCTIONS
SORINEX.COM| |3 of 3
Sorinex Exercise Equipment | 193 Litton Drive | Lexington, SC 29073 | 1-877-SORINEX | [email protected]
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF SORINEX INC.
ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SORINEX INC. IS PROHIBITED.
IF BENCH WOBBLES, LOOSEN 5/8” BOLTS. ALLOW BENCH TO
SETTLE TO FLOOR, THEN RE-TIGHTEN BOLTS.
ALIGN PAD TO THE FOUR BOLT HOLES. (AS SHOWN) SECURE 1/4” HARDWARE WITH 1/2 WRENCH.
9. 10.
11. 12.
13. 14.